SOURCE: 1996 dodge caravan headlight up/down adjustment ?
there are 2 hex screws that one is for adjusting ht and the other is for adjust in and out and they are just inside the hdlt. if you need more advice go to collisionrepairadvice.com
SOURCE: how to adjust headlights on 2005 dodge grand
on each headlamp assembly, there will be either one or two plastic nuts that you can turn.
If you only have one nut on each, that will adjust the vertical aim of the headlights.
If you have two nuts on each, one will adjust the vertical and the other will adjust the horizontal.
Park
your car on a level ground 30 feet from a wall and measure the height
from the ground to the bulb and mark on a wall (do this for highs beams
and low beams if the bulbs are separate, if highs and lows are the same
bulb, only do it for the lows)
If the headlights read VOR, then
aim the brightest part or cutoff part just below the mark on the wall.
If it says VOL or nothing, aim them 2 inches below the mark on the wall.
SOURCE: changing the headlight bulb in 2003 dodge grand
1) open the hood.
2) Carefully remove the three screws holding the
headlight assembly in place.
3) Carefully slide the
headlight assembly out. At this point you can replace the headlight
bulb, turn signal bulb, or the entire headlight assembly. To replace
the headlight bulb turn the collar holding the bulb in counter
clockwise. Pull the bulb out of the headlight assembly. Replace the
bulb. Insert the bulb into the headlight assembly insert the collar and
turn clockwise until it locks. (Do not touchglass with your fingers or it will cause the bulbs to catastrophically fail - clean with alcohol pad if you touch the glass)
4) Carefully insert the headlight
assembly back into place.
5) Replace the three screws removed in step 2
being careful not to over tighten.
SOURCE: how change headlight on 1996 dodge caravan
1.) Open the hood of your van
2.) On the passenger side of the vehicle, look behind the headlight
enclosure. You will see a set of wires running into the back of it.
This is the power clip. Either with your hand or a flat-head
screwdriver, pop the power clip off.
3.) There is a plastic ring encasing the light bulb. Turn the
ring counter-clockwise and pull it out of the socket and set it aside.
4.) Pull firmly on the light bulb to remove it.
5.) Place the new light bulb into the same opening. Be careful
not to touch the glass part of the new bulb. The oils in your skin can
substantially reduce the life of the new bulb.
6.) Replace the plastic ring and turn it clockwise to lock it in place.
7.) Reattach the power clip to the back of the bulb.
SOURCE: How do I change the headlight bulb on my 2006
Open hood. Remove 3 bolt holding headlight housing. When housing is out, remove the retaining ring by twisting counterclockwise. Pull out bulb, replace. When installing the retaing ring make sure all 3 tabs go in there slots & under the ring
127 views
Usually answered in minutes!
×