<!-- from fixya rte -->How to find a 2011 Camry DRL schematic - 2011 Toyota Camry

Question edited for clarity.
Question moved to model category.

Toyota Nation thinks fuses and DRL are headlight on low power.

https://www.toyotanation.com/threads/drl-relay.1640612/

eBay thinks it does.

https://www.ebay.ca/itm/164758754547

The Fuse and Relays diagram says No

Toyota Camry (XV40; 2007-2011) fuses and relays

Fuse Box Diagrams https://fuse-box.info > toyota > toyota-camry-xv40-20...

The fuse box is located under the instrument panel (on the driver's side), under the cover. The location of the fuses in the passenger compartment: Toyota Camry ...
Daytime running Lights are a function of the Body control Module.

https://www.google.com/search?q=2011+Toyota+Camry+LE+DRL+relay+location

..

The DRL system normally uses the same bulbs as the low beams, during drl operation the voltage is reduced to the bulbs by the drl relay which uses a duty cycle voltage, the LED bulbs will not work on this system, you can use them for high and low beams but drl won't work.

There is no DRL fuse, they are controlled through the BCM module.

DRL control module , maybe . Go to http://www.bbbind.com/free_tsb.html free wiring diagrams . To find out what is causing the problem electrical testing needs to be done . Videos on youtube ,basic automotive electrical testing , how to read a wiring diagram , how to use a DVOM - digital volt ohm meter . Check B+ voltage to the DRL control module and the ground circuit as well .Also check pin #1 at the DRL control module , this is low beam signal circuit .

must be in canada, we are USA
go to your jeep dealer and buy it

above is no question.at all
in fact is just a statement in fact.

here is one more
im adding air to my tires.

Drl (daylight running lights)

Fig. Fig. 15: 1997-00 Pontiac headlights w/DRL chassis schematic

Fig. Fig. 16: 1998-00 Chevrolet headlights w/DRL chassis schematic

Fig. Fig. 17: 1997-00 Turn/Hazard lights chassis schematic

Fig. Fig. 18: 1997-00 Park/Meter lights chassis schematic

The switch is automatic when you turn the car on. DRL stay lit as long as it is not dusk, once dusk the DRL automatically turn off and headlights turn on. Camaros are made in Canada, and DRL are universal throughout North America. What is happening is that the shed where the inspection is taking place is dark enough to simulate dusk , and the photocell is turning off the DRL and turning on the headlights. Someone at the inspection station is misinformed. DRL D=Daytime not Nighttime, which the darkness in the shed is simulating.

[Information] For a 2002 Toyota Camry, the Daytime Running Lights (DRL) operate utilizing the High Beams (inner Lamps closer to the center of the vehicle front) at a reduced power.

[The troubleshooting process:] Review the Owner's Manual and ensure the test configuration matches the following criteria:
1. According to the 2002 Toyota Camry Owner's Manual (Check your Owners Manual):
"The DRL system will make your headlights come on at a reduced brightness when:
The light switch s in the "DRL" position.
The ignition is on with the engine running.
The headlight switch is off.
The parking brake is released."

2. Set the Test Conditions according to Step 1 above.

3. Check the headlight bulbs to ensure they are not burned out. If one burns out, there is a fair chance that the other would have burned out at the same time. Replace as necessary. In this case, if the high beams operate, the DRLs should also operate.
4. Test the system, ensuring the step 1 conditions are set. (Engine running, Multi-function Switch on Turn Signals in "DRL" position, headlight switch off (repeating what the manual says -- it should be obvious that in the "DRL" position, the headlight switch should be off / do not have the switch positioned to "High Beam"), and the Parking Brake "off").
5. If DRL lights do not work, check the engine compartment Fuse and Relay Box. there is a 5 Amp DRL fuse -- replace it with the spare. Test (step 4).
6. If it does not work, swap around or replace relays -- there are three (3). Any one of them could be bad (stuck or burned out). Test (step 4).
7. Other less likely possible issues could be that the Multi-function Switch is broken or a connection / wire is broken. [Beyond the scope of this process.]

My problem was that the test configuration did not have the engine running and parking brake off - Step 1. Problem solved with much thought, repetitive tests on the vehicle and going back to the basics -- what does the Owner's Manual say and where are the applicable fuses and relays located?

It sounds like your DRL RELAY/Headlight relay. I had this happen with a 2000.

Please rate me if this helps You.

Here is some info that I hope is helpful to you.

This first part is how to disable the DRL
TOYOTA. From the Toyota technical service bulletin EL011-00 Web site for specific models determine where the module is; either the DRL relay or the body ECU, connector number, pin #. Oct 6,2000.

Avalon 1999 DRL relay D4 pin 1
Avalon 2000 body ECU B5 pin 6
Camry S/D 99* DRL relay D6 pin 23
Camry S/D 00* DRL relay D6 pin 10 *twilight sentinel
Camry Solara99/00* DRL relay D6 pin 23
Celica 2000* body ECU B6 pin 17
Corolla 99/00* DRL relay D3 pin 23
ECHO 2000 DRL relay D2 pin 12
4Runner 2000 DRL relay D8 pin 2
Land Cruiser 99/00 DRL relay D8 pin 2
MR2 Spyder 2000 DRL relay D2 pin 12
RAV4 99/00 DRL relay D17 pin 2
Sierra 99/00 DRL relay D4 pin 2
Tacoma 2000 DRL relay D8 pin 2
Tundra 2000 DRL relay D7 pin 2
-disconnect battery- Then remove the wire with pin attached and tape to the harness. (consider just cut and tape the wire) -check operation- [except the 2000 MY-Avalon, additionally you need to ground the wire at the module end of the cut wire]


And here is the Headlamp relay part number.

ACDELCO E1717C [RELAY-HEADLAMP] RELAY,HDLP OEM#89057700 ALL MAKES