<!-- from fixya rte -->Sunroof will tilt but not slide open - 2007 Hyundai Tucson Limited

1. Place the ignition switch in the ON position.
2. Push and hold the sunroof switch toward 2 . Once the sunroof has reached the full tilt position, release the switch. Push and hold the switch toward the 2 position again. After a delay of four seconds, the sunroof will make a small movement and backup.
3. Release the switch.
4. Within 5 seconds of releasing the switch, push and continuously hold the switch toward 2 . The sunroof will move from the tilt position to the open position and back to the close position.

To reset the moonroof one-touch operation:
With ignition switch in the "ON" position, do the following:
1. Push and hold the "TILT UP" side of the switch until the moon roof tilts all the way up and then tilts down slightly (approximately 10 mm [0.39 in.] at the rear).
2. Check for proper operation of the "one-touch slide open/close" and "one-touch tilt up/down" functions by pushing the switch briefly to the "SLIDE OPEN" and
"TILT UP" positions.

Slap some grease on it.

Try resetting,this works on many cars
Press and hold tilt,watch sunroof untill it raises another half inch
Close tilt and test slide

Is there a way to manually close the sunroof in the up position on a 98 Nissan Maxima?

When you turn switch to the slide back position, do you hear the motor running ? If yes, might have a blocked or bad track. This will require you to remove trim covers and glass to have access to the track. Once all parts removed, turn the switch to open as you look at the motor and track move.

there is 2 slides on each side that sit in a track its common for on of the slides to pop off the track letting it tilt but not retract if you get it to tilt take a look at the track on both sides one is prolly off pop it on and boom

hello,try to clean the rail,if not corrected,your sunroof motor need to check or replaces if necessary,ty

title says X5, but description says X3. i'll explain for an X5, but X3 with the pano should be the same. and i'll explain function of the roof, not reprogramming.

button is located on the panel at the top near the front & center windshield. its the switch on the far left on this panel. its a switch that not only toggles, but also slides forward & back.

with your finger in front of the button, slide it back & release. this will make the cover slide back and store revealing the sun roof. you know have 2 options (tilt the sunroof up or open the roof completely).

to tilt it up, press up on the rear of the button and release. the rear of both roofs will pop up. to close, push up and release the front of the button or slide the switch forward.

to slide it open completely, repeat what you did to open the protective cover (slide the switch from front to back). the roof will open completely and stow out of the way. to close, slide the switch forward and release. pano roof will now close.

to close the cover, slide the switch forward again.

neat trick: if you want to tilt the sunroof open without opening the protective cover, press up on the rear of the button (when the cover is closed) and release. the cover will separate in the middle exposing about a 2-3 inch mesh, then tilts the sunroof open. to close, push the button forward again.

also, if you are above a certain speed (can't remember what it is off hand) with the sunroof open or tilted, it will close automatically, then perform the neat trick on its own to keep air coming in.

one last trick: if you want to open the windows and sunroof from outside, press & hold the unlock button (forward button on the key) and you will see the windows go down, then the roof will open to vent. releasing the button will stop the motion of the windows & roof.

hope this answered what you were asking.