Question about 1999 Jeep Grand Cherokee
My electric windows for my 1999 jeep grand Cherokee loredo do not work how can I find the right fuze
Posted by Anonymous on
You should be able to find out the correct amp, on your owners manual..you can also remove the cover on your fuse box and there it should read the correct amp fuse for your power windows
Posted on Sep 03, 2014
The operator guide in the glove box covers this, lost that?
or see the free fsm and look it up self.>
Posted on Sep 03, 2014
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
Here's a link to this great service
Posted on Jan 02, 2017
The tail lights and the brake/turn lights use the same bulb but, there is 2 filamants in the bulb. One for tail lights and one for brake/turn lights. So just because the brake lights and turn signals work doesn't mean the bulbs are good. If bulbs are good you can check to see if there is power getting to the tail light assy's by unplugging the connector at the assy and using a test light probe the connector (harness side) with the headlights on. If you are getting power to the assy the test light will light. To make sure, turn off the headlights and test light will go off. Hope this is helpful. Good luck.
Posted on May 29, 2009
Check in the Fuse Block, the cavity 2, fuse 30 Amp c/Brkr (Section (8W Page 7)
More details about electrical system for ZJ Grand Cherokee, you can find here: ZJ-Secc-8W-Wiring-Diagrams
I hope help you with this (rated this help). Good luck.
Posted on Sep 24, 2009
There are two parts to it, a voltage resistor, and the EL panel itself.
You need to remove the console first. There are 2 screws under the front rubber pad, two under the cup holder, two in the bin. Remove those six first, take the storage bin out, then slide the rear cupholder out, remove the two screws under the cup holder, and one in front of it.
There are a total of 6 flat screws, and 3 self tapping screws you have removed.
Put the parking brake on, shift the tranny to N, and the transfer case to the middle position if equipped.
Remove the entire console. Slide the shifter beezel as far up vertically as you can. There are 4 clips you ned to remove to do it.
You will see a blue and black wire running into the back. Follow those wires to the resistor. You will see a transparent EL panel attatched to the resistor by two clips.
Usually, one or both of these clips has come loose, causing the light to work intermittantly. Clip them back on, and turn on the headlights to confirm that the light works correctly now.
Re-install everything in the opposite order.
Posted on Oct 11, 2009
Tips for a great answer:
Oct 07, 2014 | 1999 Jeep Grand Cherokee
Aug 30, 2013 | 2005 Jeep Grand Cherokee
Oct 30, 2012 | 1999 Jeep Grand Cherokee
Jul 16, 2011 | 1999 Jeep Grand Cherokee
Jan 17, 2011 | 1993 Jeep Grand Cherokee
Jan 11, 2011 | 1999 Jeep Grand Cherokee
Jul 23, 2010 | 1999 Jeep Grand Cherokee
Oct 25, 2009 | 1999 Jeep Grand Cherokee
Jan 12, 2009 | 2002 Jeep Grand Cherokee
Jul 18, 2008 | 1999 Jeep Grand Cherokee
294 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: