Where are points for timing to 1998 dodge grand caravan

SOURCE: 1998 Dodge Grand Caravan Horn Not Working

The most common problem with this is the clockspring, it is located just under the steering wheel. It will cause the horn not to work, airbag light to come on, and the cruise not to work. There is probably a recall on this. Contact a local dealer to see if the recall applies to your car.

SOURCE: how to change the air filter on a 1998 dodge grand caravan sport 3.3 l

The air filter is located towards the bottom of the engine compartment on the drivers side. It is hard to see if unless you know where it is. To get to it start by removing the two 8mm or 10mm screws which hold a piece of plastic duct work to the radiator support bracket. Next loosed the two worms clamps which hold on the round intake duct work to the engine. All of this is located on the drivers side. After these clamps are loosened remove that portion of the intake, you will have to pull a black tube off of this portion of intake also. Just remember to put it back on later. Now you should be able to see down inside the engine compartment. You will see a black box on your right side. The cover for this box is held on by metal clips. When you unclip these clips this cover will open and expose the air filter. Simply pull the air filter out and replace it with a new one. Installation is the exact reversal of this procedure. I hope this helps and please don't forget to rate me.

SOURCE: correct tire size for 1998 dodge grand caravan

should be in the 215/7515 range

SOURCE: belt diagram 4 1998 dodge grand caravan

My sincere apologies for the delayed response.
I am personally going back to answer - unanswered questions.

I do not know if you still need this information, but I am going ahead and answering it anyway. You may want to Print the Diagrams for future use.

CLICK on the following LINK. It has the Belt Diagrams you will need.
If you would: Before Clicking: Let me know if this helped you, or if you have any additional information or questions. Feel Free to contact me at FixYa.com!
Again my apologies...
Thanks!

http://www.2carpros.com/car_repair_information/year/1998/make/dodge/model/grand_caravan/1998_dodge_grand_caravan_drive_belt_routing_diagram.htm

Greg Bernett

• 2993 Answers
• Posted on May 24, 2010

SOURCE: how do you change a heater blower moter in a 1998

Removal & Installation




The blower motor is located behind the glovebox, behind the blower motor cover

1. Disconnect and isolate the negative battery cable, then wait 2 minutes before proceeding with the removal. This will effectively disable the air bag system preventing possible personal injury.
   
2. Remove the glove box from the instrument panel.
   
3. Remove the A/C-heater blower motor cover.
   
4. Disconnect the blower motor wiring connector.
   
5. Remove the blower motor wiring grommet and feed the wiring through the blower motor housing.
   
6. Remove the blower motor mounting screws.
   

1. Allow the blower motor assembly to drop downward to clear the instrument panel and remove from vehicle.
   

1. Place the blower motor assembly into position on the A/C-heater unit and tighten the mounting screws.
   
2. Route the blower motor wiring through the blower motor housing and seat the wiring grommet in the hole of the blower motor housing.
   
3. Reconnect the blower motor electrical connector.
   
4. Install the A/C-heater blower motor cover.
   
5. Install the glove box into the instrument panel.
   
6. Reconnect the negative battery cable. Check blower motor operation.