O2 sensors wiring diagrams
Locate the wires running off
from the O2 sensor. There should be two. The black wire is the ground
wire. The other wire, which may vary in color, supplies power to the
sensor.
2
Connect the power lead to the corresponding connector on the chassis's wiring harness.
3
Connect the black, or ground, lead to the corresponding connector on the factory wiring harness.
3
wires, "how do i wire it" are simply explained. all universal 3 wire o2
sensors will have 2 wires one color, the other wire a different color.
the 2 that are the same color are ground and power for the heater and it
doens't matter which one is which. so ground to the motor, power from
the gray wire on the fuel pump, or anywhere you want to pull 12 volts
while the car is running. i have a dedicated fan relay that doesn't use
the ecm and runs off the key, so thats where i went. the different color
wire goes to the stock sensor wire, it's the signal.
×