Both of my 2007 toyota camry solara headlights went out
SOURCE: Maintanance light on a 2007 Toyota Camry LE
Push and hold trip button on dash with key off, turn key on but don't start, odometer will clock down, when it is finished, lite will go off
SOURCE: What is are the correct headlight alignment specs for a 2001?
Park
your car on a level ground 30 feet from a wall and measure the height
from the ground to the bulb and mark on a wall (do this for highs beams
and low beams if the bulbs are separate, if highs and lows are the same
bulb, only do it for the lows)
For Low Beams: If the headlights read VOR, then
aim the brightest part or cutoff part just below the mark on the wall.
If it says VOL or nothing, aim them 2 inches below the mark on the wall.
For High Beams (if separate from low beams): Aim the headlight directly at the line you marked on the wall.
The adjustment screws/nuts should be located either on the top of the headlamp assembly,
behind the headlamp assembly, or near the frame rail by the radiator
support.
You will have vertical adjustment screws for each independent beam
(separate highs and separate lows, but will be same screw if highs and
lows are the same bulb). You may also have additional horizontal
adjustment screws as well
SOURCE: how to change serpentine belt on 207 toyota camry
4 cylinder diagram
6 cylinder diagram
Loosen the tensioner pulley to remove the belt. It is the one that has a long bolt running through it. Once you remove the old belt, install the new one using the appropriate diagram from the above two links. Readjust the tension using the bolt you loosened to remove the old belt.
i hope this helps
matthew
SOURCE: 2002 solara amp, does it need bypassing?
Yes, it will sound horrible. like a opera on full treble sung by a mouse if it works at all.
412 views
Usually answered in minutes!
×