No Remote
SOURCE: how to turn off the alarm manually without any use of a remote control
Just unlocking the car with the key turns the alarm off.
SOURCE: 1997 camry - remote central locking died suddenly
Hi Toyota Ed,
I can't see any black box under driver front seat. Will get husband to check when he gets home. This camry is late 1997, V6 auto, Model: MCV20 if that is of any help.??
jennyp
SOURCE: toyota camry 1997 3.0 v-6 code p0446
That code is for the evaporative emmisions system. Here is a link to an open forum you can go to, this will help you understand what it is, and why. The vehicle on the site is a van, but the code, and parts involved are one in the same, so don't worry about the difference in vehicle. The van is a toyota, and this is the information on the p0446 code. Hope this helps you.
http://steampunkworkshop.com/toyota-sienna-evaporative-canister-and-svs-valve-repair
SOURCE: Need to reprogram door locks for 2004 Toyota Camry
I recently replaced the battery on my 2004 Toyota Camry. When I installed new battery the door locks will not stay unlocked once opened with remote. How do I reprogram?
SOURCE: 2003 toyota camry how do you reset wireless entry
if remote is good here are the factory instructions to program it, if this doesn't work u may have a bad remote or receiver in car.
1. Start with the key out of the ignition, drivers door is open all others closed and
drivers door is unlocked.
2. Perform these steps within 5 seconds.
A. Insert the key into the ignition(Do NOT Turn) Pull key out.
B. Insert the key into the ignition(Do NOT Turn) Pull key out.
3. Perform these steps within 40 seconds.
A. Close then open the drivers door.
B. Close then open the drivers door.
C. Insert the key into the ignition(Do NOT Turn) Pull key out.
4. Perform these steps within 40 seconds.
A. Close then open the drivers door.
B. Close then open the drivers door.
C. Insert the key into ignition and leave it in ignition.
D. Close the drivers door.
E. Turn the ignition to ON (Do NOT Start) then back to OFF.
F. Remove the key from the ignition.
5. Within 3 seconds, the power door locks should lock then unlock automatically
indicating successful entry into programming mode.
Return to step 1 if the locks do not cycle at this point.
6. Perform these steps within 40 seconds.
A. Press the lock and unlock buttons on the remtoe simutaneously for 1.5 seconds.
B. Immediately after letting go of the lock and unlock buttons,
Press the lock button by itself and hold for 2 seconds. Within 3 seconds, the door
locks should lock and then unlock once indicating successful programming. If
the door locks cycle twice, repeat steps A and B in step 6 as the remote was
not accepted.
C. Repeat steps A and B in step 6 for each new remote.
7. Open drivers door.
Testimonial: "thanks for the greatadvice"
131 views
Usually answered in minutes!
×