SOURCE: 2001 chrysler PT cruiser 2.0 DOHC crankshaft
Front of car just above starter assembly on engine block, you'll need a 10mm and 8mm socket. Hope this was helpful.
SOURCE: where is my fuel pump located on my 2001 sebring
in the fuel; tank,,make sure thats the problem as the cost a lot!!!
Testimonial: "Thank you for your help. thats what I was affaid of. "
SOURCE: 2002 CHRYSLER SEBRING - 2.4LTR DOHC ENGINE I
There on very tight, did you insert a bolt in the hole, where the bolt for the crank bolt goes on, insert a long where it sticks out pass the pulley about 3 to 4 inches, but thinner bolt in there, and the tip of the puller on it, tighten the puller, and it will come out. I would get two of those bolt's, because it will start to bent, and you might need to used the other bolt to finsh taking it out.
Testimonial: "THANK YOU -THANK YOU-THANK YOU !!!! I RECEIVED RESPONSE THIS AM , RIGHT B/4 I WAS TO BEGIN AGAIN AND WITH THIS TIP I HAD THE PULLEY OFF IN 5 MINUTES ."
SOURCE: Crank shaft bolt torque specs for 2001 chrysler
the dampner is the crank bolt
Testimonial: "This expert is amazing, smart and extremly helpful."
SOURCE: cannot locate the thermostat on
I BELIVED IN LOWER RADIATOR HOSE IS WHER YOU WILL FIND IT AT THE ENGINE END
OF COURSE MAY REQUIRE SPECIAL EQUIPMENT TO REFILL MOST UNIT ARE NOW VACUMED FILLED
67 views
Usually answered in minutes!
×