SOURCE: E.E.C fuse keeps blowing in 1991 Ford Explorer
if you replaced fuel pump i would look at backward wiring when replaced and i would start at the source of work if your vehicle was working fine before replacement then 9 out of 10 it will be your fuel pump wireing
sometimes when putting wireing back together the connectors have the missing clip and in turn you can turn the wireing in both directions now where positive is touching the ground on both sides of connector kris kross problem check your work this is crucial use a test light to find the right wires where they go
SOURCE: i need a 2002 ford ranger fuse box diagram and afuel pump relay switch diagram
Hi
go to www.motorcraftservice.com then click on the owner guide and put in your truck information
then choose the 1st owner manual printing and should be between page # 184 to 200.
Good luck and I hope this will awnser your question.
SOURCE: I need to know what
The fuse number for the fuel pump motor is #5 located under the hood. And it takes a 15A fuse.
SOURCE: fuel pump problems 2003 s10 chev 4.3 v6
Your ECU is what acctivates your fuel pump realy. Put the key on the run possition and pull the ecu fuse for a few seconds and reinstall it ans it should accivate your realy for 5 seconds, Good luck.
SOURCE: 1997 Ford F150 Electric Fuel Pump will npt pump
Did you check the fuel inertia switch in the passenger side kick panel ?
The fuel pump is powered :
the fuse to the fuel pump relay.
The fuel pump relay to the fuel inertia switch
The fuel inertia switch to the fuel pump itself.
At the fuel inertia switch in the kick panel, power from the relay is the Dark Green w/ Yellow stripe wire and the pink w/ black stripe wire is the power. from the fuel inertia switch to the fuel pump.
If you jumper the fuel pump relay, you should hear it run. If not pull the fuel pump relay, and check the pins in the relay socket, pin 30 should be the power from the fuse.
If you have power at pin #30, jumper the relay socket as shown with the red line above, and check the dark green w/ yellow stripe wire at the fuel inertia switch for power.
Press the button on the top of the fuel inertia switch, and check for power leaving the fuel inertia switch on the pink w/ black stripe wire.
This is tests good, check for power at the fuel pump, same pink w/ black stripe wire.
Fuel inertia switch info is in the owners manual, If you did not get an owners manual with your truck ( purchased used ), you can download one from Ford :
https://www.fleet.ford.com/maintenance/owners_manuals/default.asp
In your power distribution box in your engine compartment (Ford recommends
disconnecting your battery before servicing fuses / relays in PD BOX )
fuse # 9 - 20 amp mini-fuse for fuel pump relay and RAP module
relay # 5 - is the fuel pump relay in your PD BOX
also , the fuel pump inertia (shut off) switch is in the right front passengers
footwell by the right front kick panel.
Thanks..
228 views
Usually answered in minutes!
×