How to get to master window switch and replace for a 2009 gmc acadia
SOURCE: How do I replace a lowbeam headlight bulb on a 2008 GMC Acadia
You will have to go through your mud guards. Remove your tire, and look inside your wheel well, you will see two part mud guard, front half and back half. Just remove the 7 screws from the front half, 5 on the wheel well itself, and two on the bottom, retaining screw to the bumper, now depending on which side you're looking at anywhere from 5-7 plastic pop-its. Use a flat tip screw driver to loosen the pins up, then remove the pop-it studs. There are two on the bottom front that connect to the vehicle frame. Once this is removed, you can access your headlight assemby to replace both bulbs. Note, you will have to do this to replace your fog light bulb should it go out as well.
SOURCE: 2008 gmc acadia low beam light bulb changing
how do you change the low beam light bulb on the 2008 gmc acadia
SOURCE: how to replace headlight on 2007 gmc acadia
first if you are changing the bulb only and it is a HALOGEN
there is a round acess hole in the inner fender remove it and change the bulb
if you have HID lights or are changing the head light assembly then you have to remove the front bumper facia
hope this helps
hope you have HALOGEN lights
SOURCE: 2008 GMC Acadia manual liftgate
2007 GMC Acadia manual liftgate will not open. Is there a way to bypass the electronic switch to get it open and replace the switch or latch?
SOURCE: 2008 GMC Acadia manual liftgate
{: ) Liftgate Access Plug is located at the bottom center area of the liftgate trim panel.
From inside the vehicle lower the second and third, if applicable, row seats.
Use a small flat-bladed tool to remove the access plug from the liftgate lower interior trim panel. It is like a round and smooth plastic grommet.
Push on a silver lever located on the right just through the access hole to unlock the liftgate.
Open the liftgate from the outside of the vehicle using the exterior handle.
601 views
Usually answered in minutes!
×