I have a 2003 chevy astro van can i tow 6000 lbs?

if starter motor is dead silent?
do as all do, jumper cable jump start it. (try park and neutral)
call AAA auto club, ask for a jump.
or charge the battery (a tool)
or barrow a good battery to try.
or make sure battery cables are not loose nor rusty.
if stranded?, then try neutral trick then call for a tow.
ask dad or hubby (BF) for help or brother or any other car savvy helpers. call the auto club (ins co)

Check ignition switch for power.

It has to be drilled out, until you can turn it to the run position to push the button to release it.

Could be that you need to add a lil more fluid to it.

try to tap on the blower motor with the switch in the on position the motor is located on the passenger side close to the firewall if it kicks on you need a new blower motor

6000 lbs. if it is a C1500 or K1500 and 1000 lbs. if it is a C2500 or K2500.

there is no relay power from control panel through pressure switchs to compressor

its in fuel tank.

1998 chevy astro 4.3 v6 torque specs include :
* foot pounds *
balance shaft (if equiped) gear bolt = step 1 = 15 ft.lbs. step2 = additional 35 degrees.
camshaft sprocket bolt = 18 ft. lbs.
connecting rod cap = step 1 = 20 ft. lbs. step 2 = additional 70 degrees.
crankshaft damper bolt = 74 ft. lbs.
crankshaft oil deflectorbolt/nut = 27 ft.lbs.
cylinder head bolts = step 1 = 15 ft. lbs. step 2 = additional 73 degrees. (tighten in sequence)



exhaust manifold bolts = step 1 = 11 ft. lbs. step 2 = 22 ft. lbs.
flywheel bolt = 74 ft. lbs.
main bearing cap bolts = step 1 = 15 ft. lbs. step 2 = additional 73 degrees.
oil filter adapter bolt = 15 ft. lbs.
oil pan bolt/nut = 18 ft. lbs.
oil pump bolt = 66 ft. lbs.
rocker arm with press in studs = 18 ft. lbs.
rocker arm with screw in studs = 19 ft. lbs.
valve lifter retainer bolt = 12 ft. lbs.
water pump bolt = 33 ft. lbs.
* inch pounds *
balance shaft retaining plate bolt = 106 in. lbs.
camshaft retainer plate bolt = 106 in. lbs.
front cover bolt = 106 in. lbs.
intake manifold upper = step 1 = 44 in. lbs. step 2 = 88 in. lbs.
intake manifold lower = step 1 = 27 in. lbs. step 2 = 106 in. lbs. step 3 = 133 in. lbs. ** (tighten bolts in sequence)



thanks for your vote !