Malfunction code P1310
Error code: P1310
Description: Igniter number 3 circuit malfunction.
Solution:
- Igniter No. 3 defective.
- Wire harness.
- IGT signal. (Ignition timing signal)
- IGF signal. (Ignition confirmation signal)
- Cam angle position sensor.
Google the code & read about it
SOURCE: car codes
When you have P0440, P0441 and P0446, it is a very good bet that the fuel cap was loose, or the fuel cap rubber seal is compromised. You will get all three of those codes every time that the cap is loose. Always make sure that the fuel cap is as tight as you can get it after you refuel.
SOURCE: PO725 Engine speed sensor circuit malfunction
Trouble Code: P0725
A/T Engine Speed Sensor Circuit Malfunction
Possible Causes:
Check for trouble codes related to the CKP Sensor
CKP Sensor signal circuit open, shorted to ground or to power
CKP Sensor is damaged or has failed (open or shorted)
Intermittent wiring or connector problems
PCM has failed
SOURCE: transmission codes:
I WOULD TRY REPLACING THE INPUT SPEED SENSOR..A DEFECTIVE SPEED SENSOR CAN CAUSE ALL OF THESE FAULTS..IT IS LOCATED IN FRONT OF TRANS ABOVE SOLENOID PACK..IT IS THE ONE CLOSEST TO THE ENGINE..IT SCREWS INTO TO TRANSMISSION..A 1 INCH SOCKET FITS IT..ALSO CHECK WIRING TO BOTH SPEED SENSORS..A SENSOR IS ABOUT 35 BUCKS,AVAILABLE AT YOUR LOCAL DODGE DEALER..GET A NEW ONE AND YOU'LL SEE WHAT IT LOOKS LIKE..FAIRLY COMMON PROBLEM..HAVE REPLACED LOTS OF THEM
SOURCE: code P0325 Knock sensor 1 circuit malfunction
Code P0325 Knock sensor 1 circuit malfunction (bank 1 or single sensor)
SOURCE: How do you fix an Igniter Circuit Malfunction -
The problem 95% of the time is an ignition coil, if you do not have special equipment, your only tool is common sense, disconnect plugs from spark plugs, remove spark plugs,now insert the plugs in the wires and set them together touching metal ground them,
Ask somebody to crank vehicle one of those wires or 2 of them if the coil is bad wont fire or the spark will be weak and orange, blue is ok. Follow the no spark or weak spark to the coil, now swap coils , repeat the same procedure if the problem follow the coil to the wires that were ok before the problem is the coil if the problem is still in the same position the problem is harness wires or computer.
If you need further help, I’m available over the phone at https://www.6ya.com/expert/flavio_517b938f50183b92
P0305....Cylinder 5 Misfire Detected
so somewhere their is a faulty coil
1,482 views
Usually answered in minutes!
×