Is there a diagram picture for timing marks on Ford focus single overhead cam
Depending on trans and engine mount type the mark my be on flywheel but generally most cars it is located on the belt pulley attached to crank rod, center bottom one on engine block. the timeing mark should be visable from top looking down. if you use a big ratchet to turn over the engine by hand and go slowly, you should see thhe marks pass as you do so.
SOURCE: tourque specks
Good day;
Is it the rod connecting cap you talking about if so here is the specs 89 lbs (120 N.m) If this it not you are looking for please let me know.
Cheers.
SOURCE: I need a diagram for a 2.0 L. 2003 Ford Focus duel
Hope this helps....Not sure about your exact equipment in the vehicle, but this should help I hope
SOURCE: timing marks for 2000 ford focus
Click on the following direct Link.
With the DOHC you will need the Camshaft Sprocket Holding Tool and Camshaft Alignment Tool.
Let me know if this helped, or if you have additional information or questions. Feel Free to contact me at FixYa.com!
http://www.2carpros.com/car_repair_information/year/2000/make/ford/model/focus/2000_ford_focus_timing_belt_diagram_marks.htm
SOURCE: diagram for timming belt on 2002 ford focus 2.0ltr
there isnt marks!the cam pulleys have do nothing with timing!remove the valve cover and see in the other end of the camshafts and find two eccentric cuts!turn the crankshaft to the top dead point on the cylinder 1 the two cuts must be in the same line on the upper or lower side.you need aspecial tool to lock the camshafts and another to lock the crankshaft!this is the timing procedure!now you can change anything you want!note!the cam pulleys are conejointed to the camshafts!no marks no pins no safe pins etc.isnt difficult but complicated simple!
Testimonial: "thank you"
I do not have a diagram but i do have a site with very detailed instruction on how to set the whole thing up correctly, just click HERE
807 views
Usually answered in minutes!
×