Where can i find a engine diagram of a dodge 1999 3500 van

BBB Industries online under Technical

Hi Larry Grant,

I don't see 2011 at rock auto... really odd for a great ENGINE.

2010 DODGE RAM 2500 PICKUP 6 7L L6 DIESEL Turbocharged Camshaft Position...

Take a look on eBay
3results for CAM Sensor for Dodge 6 7

More Information for DORMAN 907726

NEW CAMSHAFT CAM SHAFT POSITION SENSOR CPS FOR 2008 20112 DODGE RAM 6 7L 5...

The camshaft position sensor is inside distributor. The crank sensor is on the front bottom of engine see diagram

2003 model
not confirmed
crank angle sensor might be near the stater motor on the block

I assume you checked and are missing spark?

have you unplugged the cam sensor and tried to start?

I’m happy to assist further over the phone at https://www.6ya.com/expert/jeremy_d728a59f986299fa

Hi,
The codes you gave are:
P0720 = Output shaft speed sensor error P0731 = First gear incorrect ratio Replacing the Output shaft speed sensor should clear that up and help your transmission. Around $20 or so. The limp mode is probably caused by a faulty cam position sensor or crankshaft position sensor. Overheating: Did you verify that your cooling fan is coming on? Kicking into a higher speed with the A/C on? Thermostat of the correct heat range and installed with spring end into engine block? Coolant is not rusty looking or weak? (check specific gravity) Flush and refill system if not nice and green or orange/ is rusty looking. Water pump is circulating coolant properly? (open radiator and observe circulation, feel top hose for fluid surging) if not, bad pump. Any of those will cause overheating. Hope that helps! Please rate this answer.....Thanks, Mike

Crank sensor is in the bell housing of the transmission. Cam sensor is in the distributor.

Code P1391 Loss of crank or cam sensors,P0340 No cam signal at the pcm. I would replace the crank sensor first. Your cam sensor is part of the dist. on 5.2/5.9 engines.
Hope that helps.

Hi...
The Code P0340 on your Stratus is :
Camshaft Position Sensor Loss signal.
Ok, The first step is check tha condittion on the connector.
For corrosion, bent pins or damaged wires.
If you found that everything is ok.
Replace the Cam Position Sensor.
The Cam Position Sensor, Is common that the Cam fail on this Vehicle and similars of this.
Tha Cam position sensor Is located:
At end of the engine head, driver side. Is attached with 4, 10mm
screw, and the connector at the center of the sensor.

I hope this help on your problem.
Thank you for use fixya...