How do you Change from km to miles 2009 Toyota rav4?

There is no fuse for just the odometer, has main fuses for the whole instrument cluster . Odometer not working? instrument cluster problem. Have it checked by a professional repair shop.

Odometers
Each instrument panel cluster (IPC) is equipped with a season odometer and 2 trip odometers. The IPC uses the odometer rolling count message from the powertrain control module (PCM). The rolling count value is determined by counting the speed pulses from the vehicle speed signal (VSS). The IPC uses the rolling count data from the PCM and a software program to determine vehicle mileage. The odometers can be displayed in miles or kilometers. The units displayed is switched between English and metric by pressing the menu button on the driver information center (DIC) until the units mode is displayed. Pressing the set/reset button will select between English or Metric. . When the set/reset button is pressed to show the odometer in metric, km and the number will be displayed. When the odometer is in English, MI and the number will be displayed.


Season Odometer
The season odometer displays the total accumulated miles or kilometers of the vehicle. This value is permanently stored in the IPC. If an odometer malfunction occurs or if the IPC must be replaced, an authorized Delco service center must be contacted to program proper vehicle specifics, including mileage, for the IPC. The season odometer is capable of displaying 999,999 kilometers or 999,999 miles depending on units selected. Leading zeros are not displayed. The display will not roll-over to 000,000 if the maximum displayed miles or kilometers are reached. If the display limit is exceeded, the maximum value (999,999) is displayed. If the mileage is above 621,503 miles and metric units are selected the odometer shall display 999,999 km.


Circuit/System Testing
Ignition OFF, raise the vehicles drive wheels.
Engine ON, transmission in drive, verify the scan tool Vehicle Speed Sensor parameter matches the speedometer display.
? If the Vehicle Speed Sensor parameter does not match the speedometer display, replace the IPC.
Verify that the odometer is operating properly.
? If the odometer is not operating properly, replace the IPC.

Hey, all you need to do is change your settings from imperial to metric or metric to imperial.
Your owners manual will have the exact steps on how to perform that, be sure to give that a good read if you haven't yet about 15 minutes and you'll learn a whole lot of cool features you might not have known about your car yet.

On the display go to settings or tools and see there if this option is available.

check your manual or ask a friend how to access the menus to change from metric to US

There is a reading on the Lower Right that indicates if it is Km or MI, It sounds like your Instrument Cluster is going bad or someone made a mistake with the Mileage on the Oil Change Sticker.

Pay close attention for the next few days and see what happens....

It should be in your owners manual if it can be done.
On some models there is a us-metric button for the display or you can go into settings in the computer and change it there.

Disconnect the battery for 90 seconds, then unplugged the cluster.. Then connect the battery with no cluster.. HVAC display changed to metric...

Re-connected the cluster again, display changes to imperial...

The cluster is what dictates what is displayed. It is metric by-default but a US imperial instrument cluster overrides that.

there should be a menu button some where on the dash that will let you select it also it might have the gauge with both mph and km on it your owners manul should tell you how to change it

there is a button on the dash, it says ENGLISH/METRIC, push it.

okay,for one,the odometer doesnt read in miles per hr,it reads miles driven, and two i have no idea if its possible to change the odometer to km traveled,if you're talking about the speedometer,its already there,get a european cluster :p