-
Ford Master
4,390 Answers
- Posted on Jul 07, 2009
Re: I need to replace a rear seat belt in a 1997 Ford...
Please don't forget to rate, thx.
Retractor and Tongue—Sedan
SPECIAL SERVICE TOOL(S) REQUIRED
Description
Tool Number
Safety Belt Bolt Bit
T77L-2100A
NOTE: Safety Belt Bolt Bit T77L-2100-A should be used for safety belt removal and installation.
Removal
-
Remove rear seat cushion. Refer to Section 01-10 .
Seat Cushion, Rear
Sedan
Removal
-
Apply knee pressure to lower front portion of the rear seat cushion. Push rearward to disengage rear seat cushion pad and frame (600A88) from rear seat cushion front retainers (63370).
-
Remove rear seat cushion from vehicle.
-
Remove rear seat back. Refer to Section 01-10 .
Seat Back, Rear
60/40 Split Bench—Sedan
Removal
-
NOTE: Safety belt bolts do not secure seat back to vehicle.
Remove rear seat cushion as described.
-
Fold down back seat and remove two bolts in the center of each seat back striker plates.
-
Remove two bolts from outboard rear seat back frame retaining brackets.
-
Lift seat back up and pull forward to remove from vehicle.
-
Remove panel (52018) and quarter trim panel (31012). Refer to Section 01-05 .
Trim Panel, Quarter—Sedan
Removal
-
Remove rear seat. Refer to Section 01-10 .
-
Pull up on rear section of rear door scuff plate that overlaps lower quarter trim panel.
-
Pull lower quarter trim panel away from body.
-
Remove safety belt retaining bolt.
-
Feed safety belt through lower quarter trim panel.
-
Remove safety belt anchor plate-to-sill bolt from quarter panel.
-
Remove retractor anchor nut and retractor from rear quarter panel.
-
Remove upper seat belt anchor bolt and anchor from upper rear quarter panel.
-
Slide anchor plate end of safety belt through the openings in the quarter trim panel.
-
Remove outboard front safety belt retractor and tongue (611B08) from the vehicle.
Item
Part Number
Description
1
386277-S190
Bolt (Part of 611B68)
2
31012
Upper Rear Quarter Trim Panel
3
611B60
Retractor and Tongue
4
N800937-S190
Nut
5
389370-S190
Bolt
6
—
Rear Quarter Panel (Part of Body)
7
52018
Lower Rear Quarter Trim Panel
8
—
Mounting Stud (Part of Body)
-
Remove seat belt anchor bolt and retractor and tongue from rear deck panel.
Installation
-
To install, reverse Removal procedure.
-
Make sure the safety belt webbing is not twisted. If it is, remove the twist.
-
Tighten retractor anchor bolt and safety belt anchor plate-to-sill bolt to 34-46 Nm (25-33 lb-ft).
-
Check the restraint system for proper operation.
×