Question about 2000 Toyota ECHO

Open Question

2000 toyota Echo TPS spec's

Throttle position specifications (spec's

Posted by on


6 Suggested Answers


6ya staff

  • 2 Answers


Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017



  • 85216 Answers

SOURCE: reading coder on toyota echo

I am sorry but no, there are different codes some are P codes, some are B codes, and there are other ones, OBD 1 (84-96) systems could flash the check eng lite and give you codes, but they were just two numbers like 12. A typical OBD 2 code is like this P1546, this is a emission code. Kragen auto or any of the chain auto parts stores will read the codes for free.

Posted on Sep 09, 2008



  • 318 Answers

SOURCE: toyota echo 2000 - airconditioner belt squeaking

well the belt could be loose or the compressor may be seized.....or the belt may be old and squealing.

Posted on Jun 22, 2009


Richard Hale

  • 4399 Answers

SOURCE: Which is the fuse to

Usually the fuse box has the diagram. Does yours?

Posted on Mar 06, 2011


  • 1 Answer

SOURCE: i have a 85 toyota celica, it wants to idles up and down tps is n

85 celica hesitation ture acceleration and no power when i set the timing to 5dehree

Posted on Jan 21, 2012


  • 697 Answers

SOURCE: 2000 toyota echo, transmission won't shift to 4th

With such a small engine, the automatic Echo won't shift into overdrive (4th gear) until a certain engine/transmission temperature is reached. This is to protect the bearings and gears from too much torque and stress while the oil is still cold and not flowing at it's optimum level. Usually when the blue "cold" light on the dash shuts off, the transmission will up-shift to 4th. When it is very cold, it could take another few minutes of driving before it will do so.

Posted on May 05, 2012

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

How do i do an idle relearn

2000 Toyota Sienna Throttle Position Sensor (TPS) and Idle ...

? 1:30
Dec 6, 2012 - Uploaded by Dean Ferraro, EA
Where is the Throttle Position Sensor (TPS) and Idle Air Control (IAC) Valve located on my 2000 Toyota ...

Aug 25, 2015 | 2004 Toyota Sienna

1 Answer

How to test the TPS

the two are not connected if the CO readings high then its a new cat providing the lambda sensors are working

Aug 07, 2014 | 2000 Toyota ECHO

1 Answer

How to test and the specifications for the TPS

throttle position sensors do not require calibration!

Aug 07, 2014 | 2000 Toyota ECHO

1 Answer

How to test & specs' on the TPS

Keep the ignition switch to ON engine OFF. Hook the scanner, diagnostic computer or Techstream and take the reading. With the throttle pedal fully released it should read the TP sensor value between 9.8% to 18%.
It is better to keep the value as close as to 9.8%. To adjust the TP sensor, loosen the two torx screws, and adjust the sensor to the desired value.

Aug 07, 2014 | 2000 Toyota ECHO

1 Answer

How to test the TPS on my 2000 Toyota Echo the spec's

Check engine light should be on and an OBD scanner would show a code for TPS. What is the issue?

Aug 07, 2014 | 2000 Toyota ECHO

1 Answer

Throttle position sensor

Have you checked generic & enhanced data for codes
with a scan tool?

Have you scoped the TPS to put that to rest?

Your putting in throttle, but the ecu is not adding air calculation
or fuel,so you need to do some testing to see what's missing.

Starts & runs good, but under load or higher vacuum it bogs,so
check the egr system or any vacuum related systems.

Check for vacuum leaks,intake,exhaust before converter & evap system

Mar 09, 2014 | Toyota ECHO Cars & Trucks

1 Answer

Where is the throttle position sensor on my 2000 Toyota celica gt? What would be signs that the TPS is bad on my car?

It is on the throttle shaft,2 little bolts . Should have turned on the check engine light if it's bad ,would stumble and possibly die on acceleration,best to get it scanned at a parts house to see if it has a TPS code or not

Oct 01, 2013 | 2000 Toyota Celica

1 Answer

How do you take of the throttle positioning sensor

Never make an attempt to disassemble the throttle plate. Nothing to do with it. Simply clean it and relearn the idle speed control speed.

Sep 08, 2012 | 2003 Toyota ECHO

2 Answers

Toyota Echo Automatic 2000 model. Stalls at low revs and shudders when taking off slowly. Replaced spark plugs fuel filter and air filter didnt seem to make any difference. Any ideas?

Sounds like a fuel problem. Check fuel pump and fuel rail. Do a fuel line pressure test. Try cleaning inside of throttle body really good and also the TPS at that location. There's many things that can make a car run bad. 

Jul 12, 2010 | 2000 Toyota ECHO

Not finding what you are looking for?
2000 Toyota ECHO Logo

Related Topics:

43 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts


Level 3 Expert

85216 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22485 Answers

Jonah Oneal

Level 3 Expert

14092 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides