On my toyota camry , srs code B0106, how can i fix it?

**GET A SPECIALIST TO DO THIS ONE!**
The code B0106 reads as
"Open In P Side Air Bag Squib Circuit / 54"
This means there is a fault in the wiring that sets off the passenger side Airbag! Get a good auto electrician to fix this.
It could be something as simple as a loose wire, However, The 'squib' is the charge that sets off the Airbag and it is based on the idea of a blank shotgun cartridge, so unless you're an experienced auto electrician DON'T mess with it.

you mite want to go to another dealer it just should need to be recaibrated I drive a 05 and iv had to do mine before write the code its got and I can check Monday.

56 is something to do with Trac control/ abs. Possibly no signal from a pressure sensor.

did you google(using toyota directives>?)

Air bags bad.
get the FSM and read every word and the extreme dangers messing here.
no year stated
no model car. no car actually stated? wow.
no country. SSDD.
ok go to alldata.com and read.
or buy the FSM.
Squib is the explosive device, is faulting.
a squib means a low power explosive.
used in big guns to test fire , or clear a barrel or for parades ,etc.
name was stolen to car industry.
in Viet Nam we called it a short round ( it was , short)
in the car they are shot gun load sizes, and are to be respected at all times. killed many a would be mechanic.

the bad reads open circuit , or the wire is cut or the connector bad
or the bag is SHOT.
random toy , i guessed for you .
http://library.worldtracker.org/Car%20Manuals/Toyota%20Echo%202000-2002%20Approved/techinfo.toyota.com/ileaf/02toyrm/02toypdf/02rmsour/2002/02echorm/di/rs/cib01065.pdf


FSM , DTC index list
Trouble Code Conditions:
* Open circuit in P squib wire harness or P- wire harness of squib * P squib malfunction * Airbag sensor assembly malfunction
Possible Causes:

• *Front passenger airbag assembly (P squib)
• * Airbag sensor assembly
• * Wire harness

tread lightly fooling with air bags or BOOM.

Vehicle under warrenty for 5 yrs so return to dealer ,this requires special software via the internet so you will not be able to reset anything yourself

Whenever this warning light or any other stays on in the dash it is indicating that the systems control module (or the system sensor in the case of lights like low oil pressure, door open indicators etc.) has detected a fault, it then disables the system (this applies to ABS,TCS, TCM, SRS and BCM faults and others) as long as the light is on. You must now have the dealer hook up a special electronic diagnostic tool and "scan" the system for the fault code that is stored for the problem(s)

Legend of Abbreviations. ABS Antilock brake system.TCS Traction control system, TCM Transmission control module, SRS Supplemental restraint system, BCM Body control module

You need additional secondary code; try in this link: DTC B0106/cib01065.pdf


Hope this helps; also keep in mind that your feedback is important and I`ll appreciate your time and consideration if you leave some testimonial comment about this answer.

Thank you for using FixYa, have a nice day.

Just another MIL Lamp

SRS ---safety restraint system (air bag etc )
System Failure

The 'passenger side squib circuit' is the wiring that goes from the center airbag computer (under the center console) to the passenger side airbag.