SOURCE: Need torque specs for oil pan gasket
There likely is a spec for oil pan but unless you are a finatic, you really don't need to know what it is. Simple rule: Don't crank down ******* any fastener. If corners near crank ends have larger fasteners, you can tighten them a bit more than on siderails. Before tightening anything, install all bolts finger tight, to ensure that they are not cross threaded. To avoid warping pan, tighten from the center of the pan, working towards both ends, alternating from side to side as you go. When you are finished, go over it again, using the same amount of force on each bolt. As I said, end bolts can if larger in diameter, be tightened more but be careful not to tighten so much that you will either split or push the gasket out the sides.. Anywhere two gasket ends **** together, I recommend using a sensor -safe dab of silicone. An oil pan is not under any mechanical stress or pressure. I have used this method for many years and NEVER had one leak. If you really need #s, small fasteners get about 12-15in lbs, larger ones about 20.
SOURCE: Need torque specs for oil pan bolts
torque specs for these bolts can be found in a Haynes or Chilton manual availiable from your local parts store, or maybe at your local library, however these bolts are usually no more than 14 ft pounds, unlike cylinder head bolts, the bolts do not need to have any stretch factor to hold the oil pan gasket in place or sealed.
SOURCE: need to know how to remove oil pan with engine
3.8L Engine
Fig. 2: Oil pan assembly - 3.8L engine
SOURCE: replacing a oil pan gasket on a 2000 ford focus
its a simple job no exact torque is needed as the bolts you are tightening will only require a ten millimeter socket to do it equivalent to a 1/4 inch bolt just snug them and top it all of with a half turn beyond that.simple job really .
345 views
Usually answered in minutes!
×