Transmission removal
SOURCE: 1998 nissan frontier 4x4
Well since the lights are controlled by the OBD (on board diagnostics), you'll have to reset it. You may be able to do this by simply disconnecting the battery for a few hours. However, a lot of newer vehicles have electronically locked radios which require the manual to be able to be re-enabled.
I'd check out the radio before disconnecting the battery.
The only other ways are to physically disconnect the lights in the dash or get someone with an OBD reader to clear the codes.
SOURCE: 1998 Nissan frontier: where is the ignition coil?
the coil is inside the distributor under the cap.
SOURCE: 2004 nissan frontier crew cab radio
the plastic around the gear shifter will pop up with a good pull, then turn it side ways to get over the shifter, then there are 2 screws the hold the bezel down around the radio and air vents, then just pull from the air vents it will pop off to reveil the screws to the radio
SOURCE: replace seat belt on 2000 nissan frontier
Should be a T50 or T55. Should have a cover over the bolt. Remove the cover, and remove the bolt.
SOURCE: replace the brake light switch
Check the brake fluid level in the master cylinder and make sure the E-brake is not on. The "BRAKE" light does not come on because the brake switch is bad.
I’m happy to assist further over the phone at https://www.6ya.com/expert/jeremy_d728a59f986299fa
66 views
Usually answered in minutes!
×