Where is the cooling fan temperature switch in a 1997 Mercury Villager...cannot find a diagram

Dave C

• 1050 Answers
• Posted on Apr 23, 2009

SOURCE: need a picture of wiring diagram for 95 mercury

Here:

SOURCE: location or diagram of pump relay switch

The Constant Control Relay Module (CCRM) is in the right hand front of engine compartment, mounted to upper radiator support.

SOURCE: 1997 mercury villager, engine removal?

I have'nt done one myself but a friend tells me it is way easier to come out the bottom of the van.Just undo struts at the top ,remove brake lines undo motor mounts and remove framework bolt and take it out as a unit.Getting it up through to mo looks impossible.

ZJ Limited

• 17989 Answers
• Posted on May 17, 2010

SOURCE: Alternator Removal

Alternator - REMOVAL & INSTALLATION

1. Disconnect the negative battery cable.
2. Raise and safely support the front of the vehicle securely on jackstands.
3. Remove the passenger side engine and transaxle splash shield.
4. Remove the alternator wiring harness bracket bolt from the rear of the alternator.
5. Disconnect the alternator electrical connector from the alternator.
6. Remove the ground wire nut and wire.
7. Remove the B terminal wire boot. Remove the B terminal nut and wire.
8. Loosen the inner and outer alternator to bracket mounting bolts.
9. Loosen the alternator adjustment lock bolt.
10. Turn the alternator adjustment bolt counterclockwise to loosen the belt.
11. Remove the belt from the alternator.
12. Remove the alternator lock bolt and washer.
13. Remove the inner alternator to bracket mounting bolt and two washers.
14. Remove the outer alternator to bracket mounting bolt and two washers.
15. Remove the alternator.
16. The installation is the reverse of removal.
17. Adjust the drive belt. For the procedure, please refer to General Information and Maintenance, Routine Maintenance and Tune-Up, Belts, Adjustment, Alternator.
    

SOURCE: 1997 Mercury mystique the engine cooling fan will not operate

it could be the engine coolant sensors on the thermostat housing it controls the fans when they work if your sensor is out you can unplug the sensor while running the motor and if they turn on after a moment(the fans)then the sensor is bad if not make sure your fans work by jumping power to them 12volt