SOURCE: 1996 gmc jimmy
MOST LIKELY THE FUEL PUMP HAS FAILED, WHEN U TURN THE KEY TO RUN POSITION DO U HEAR A HUMMING NOISE FROM THE FUEL TANK? THIS NOISE WILL STOP IN ABOUT 5 SECONDS, U CAN HEAR IT BETTER BY TAKING OFF THE GAS CAP AND LISTENING THERE, IF U HEAR NOTHING THEN THE PUMP WILL HAVE TO BE REPLACED.
SOURCE: How do I remove the rear axle to replace the seal 1996 jimmy
You will have to remove the differential cover on the rear end, in the center of the gear cluster you'll have to rotate your axle until it exposes the ends of the axle shafts, push in the axles as far as you can from the brake pad assembly area, then, there this a C clips that slips into a groove on the end of the axle, you'll have to reove the C clip to pull out the axle.
SOURCE: 1996 GMC Jimmy will not shift into overdrive.
4th gear failure is a common problem with this transmission, assuming it is an automatic. You should have the vehicle checked for codes by a qualified repair center with the proper scan tool. Also, check fluid level and condition. More often than not, the trans loses 3rd and 4th gear, as these are working off the same set of clutches. 3-4 clutches apply in 3rd, and when the 4th shift is made the 2-4 band applies giving you overdrive. If you have no engine braking in manual 3rd, you definitely have a mechanical failure, no 4th could be an electrical, or mechanical fault.
SOURCE: wath P1406 Code means on a GMC jimmy 1996,
It's an egr valve problem (exhaust gas return) egr position sensor.
Take off the egr valve and turn it over and see if there is carbon build up in the ports, if there is clean it out with a pipe cleaner and a little carbon cleaner, just spray a little into the ports and clean it out. If that doesn't cure the problem, then either the sensor needs replacing, and or the egr valve.
Testimonial: " thanks for yout help"
187 views
Usually answered in minutes!
×