2001 GMC Yukon denali truck crank over but stop immediately

SOURCE: '04 GMC Yukon Denali Check Engine Light

Did u put in fuel shortly before the light came on? I own 2 service centers & the most common situation with "Check Engine" lights are because the fuel cap wasn't re-installed or not tightened. When you refuel make sure it "clicks" when putting back on. We don't charge for a "Code Reading" but a dealer will, don't go there. Go, like the others suggested. If it is the fuel cap & you re-install it correctly, the light will go off after a short drive. Good Luck. PS-Don't panic when the "Check Engine" light comes on unless it blinks, if that happens don't drive. PSS-RE: Murray's, Auto-Zone.......If it's a "Code" (the reader will give a #) the code book will tell you the problem. PSSS-Some1 please have Troy W's Mommy & Daddy take away his keyboard. Just because you can put together a "Lego" car doesn't make you a master mechanic. You only repeated what we said except you have a "Napoleon" complex against any1 plugging something in to a vehicle. It's the same as plugging in a light @ home. In conjunction with "kinder" nine out of ten time in my experience it usually is the oxygen sensor(s) which would be about right with the year model

SOURCE: location of fuse box/panel for 2004 yukon denali xl

There are 2 fuse panels in the Denali.
One is a panel on the drivers side, its on the dash but facing the door.

The ohter is under the dash and above the pedals, this one is much tougher to access.

Your Owner's Manual should tell you where the fuses are that you need to access.

SOURCE: 2005 gmc yukon xl denali service ride control

it has to do with your air ride suspension best bet is take it to the dealer there is probably a problem with a level sensor. hope this helps you

SOURCE: 2003 GMC throttle position sensor

try www.schramauto.com or call them at 1-800-292-1032

SOURCE: gmc yukon has the abs & parking brake light

you have to fix the problem with ur brakes- first check the wiring ,connectors and connection clips to the abs sensors and modulator if looks ok than have truck scanned some auto stores such as auto zone / advanced auto do it for free the code will give u a start point towards fixing ur problem--visual inspection of brakes doesnt always show problem