- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
Blown fuse ,bad headlight switch,or wiring issue.
the tail lights have there own fuse and are powered through headlight switch. Do the front running lights come on? If none of them work, switch could be bad if front work and rears dont, check bulbs and power to them when lights are on
Make sure bulb replaced is the required 2 way or 1 way. If you're sure you put in the right bulb type (1 way or 2 way) 6 or 12 volt.. bulb model marked on side for replacement (Check carefully). Assuming its the right bulb type and still blinks fast, you will have to replace the socket. Sockets do get corroded and worn. Disconnect the battery, cut positive then cut negative. Wire up new socket same way using wire connectors. Tape up connections after.
Should then work.
Make sure before you do this you have the right bulbs in all sockets (front and rear) and that all lights work 1st. One failing light front rear same side can cause this problem.
Go to a scapper to get a socket.. just cut it off a wreck... take a couple of them. There cheap.
Good luck
The only way a lot of bulbs can burn out at once is overvoltage. Check your charging voltage with the car running, using a multimeter. Should be 13.8 volts; with the car off, about 12.6.
×