ALL KEYS WORK IGNITION, ALL REMOTES WORK... CAR DOES NOT ALWAYS CHIME WHEN KEY IGNITION WHEN IT DOESNT CHIME THE FACTORY RADIO DOESNT WORK ..WHATS GOING ON
SOURCE: 2005 Pontiac SV6 Montana key fob unlocks doors but will not lock
For the sliding doors you need to clean the contacts, there are 6 or 8 on both sides, just wipe them clean as they are probably covered in oil/grease/grime.
SOURCE: Noise when turning the key to start my 2005 Pontiac Montana
might be the fuel pump. should sound like an electric motor running, whirring sound. like a very quiet dough mixer.
SOURCE: Pontiac Montana SV6
For instructions on how to program remotes and keys check website below, I use these and they are usually very accurate. This website does state that on your vehicle, special equipment is needed to program a key fob, as there is no onboard programming for it. However, there are programming instructions for transponder keys.
http://www.programautokeys.com/
http://www.programautokeys.com/
Hi Melissa
I have this procedure for Pontiac, try it
Obtain all remote transmitters for this vehicle.
1. Close all doors.
2. Insert key into the ignition cylinder but do not turn it.
3. Press and hold the Unlock button on door lock switch on drivers door.
Hold until instructed to release.
4. Remove key from ignition and then insert key into ignition without turning ignition cylinder and remove key.
5. Insert key in ignition a third time and leave key in ignition. Do Not turn ignition.
6. Release door lock switch on drivers door panel.
A Chime will sound 3 times indicating that you are in programming mode.
7. Press both the Lock and Unlock buttons on the remote up to 30 seconds.
A chime will sound 2 times if remote has programmed successful.
8. Repeat step 6 if you are programming additional remotes.
9. Remove key from ignition to exit programming mode.
NOTE: If you are having trouble getting this procedure to work, we have found that some vehicles need step 3 to be done before step 2
268 views
Usually answered in minutes!
×