Is there a reset inertia button for a fuel pmp 94 Mazda 626 2.0?

SOURCE: my new 94 mazda 626 2.0 is very hard starting

tap on the gas a couple of times then try to start it.

SOURCE: how do i replace the fuel pump in my 1993 mazda 626 2.5

1. Relieve the fuel pressure and disconnect the negative battery cable.

2. If not already removed, depress the clips on each end of the rear seat cushion and remove the cushion.

3. If not already done, detach the electrical connector from the fuel pump/sending unit.

4. Remove the attaching screws from the fuel pump/sending unit access cover and remove the cover.

5. Disconnect the fuel supply and return hoses from the fuel pump/sending unit.

6. Remove the attaching screws and the fuel pump/sending unit from the fuel tank.

7. Detach the sending unit electrical connector, remove the sending unit attaching nuts and remove the sending unit from the fuel pump assembly.



To install:

1. Attach the sending unit to the fuel pump assembly and install the nuts. attach the sending unit electrical connector.

2. Install the fuel pump/sending unit into the fuel tank with a new gasket and install the mounting screws.

3. Connect the fuel supply and return lines.

4. Install the access cover and the mounting screws.

5. Attach the sending unit electrical connector.

6. Position the rear seat cushion over the floor, making sure to align the retaining pins with the clips. Push down firmly until the two retaining pins are locked into the rear seat retaining clips.

7. Connect the negative battery cable, start the engine and check for proper system operation and for fuel leaks.

SOURCE: How to Replace a Fuel pump on a 2000 Mazda 626

yes it isn't that much if you buy them.they slide inside the coupler and release the line.

Testimonial: "Thank you didn't know if there was a tool for this."

SOURCE: where is 1999 mazda fuel pump located?my mazda 626

Hiya,
The fuelpump is located in the fueltank and is accessible by removing the rear seat squab. Under the squab is a service panel that will have a few screws holding it down. remove the panel and instead of removing the pump try giving it a firm rap with a hammer handle or piece of solid wood taking care not to damage the wiring or fuel lines exiting the top of the pump assembly. This may be enough to get the pump to work again.

Regards

GeckoNZ

SOURCE: is there a reset button

no there is not a reset button or fuel inertia switch for this vehicle.