Question about 2004 Audi A3 Sportback

1 Answer

Battery went flat on my audi a3 2004 tdi esp light on how do i reset my angle sensor please can i reset the fault with a snap on souls diagnostic tool

Battery went flat esp light came on and stayed on can it be reset with snap on solus diagnostic tool

Posted by Anonymous on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Genius:

    An expert who has answered 1,000 questions.

  • Master
  • 1,041 Answers

Try it & see

Posted on Dec 06, 2016

Ad

6 Suggested Answers

6ya6ya

6ya staff

  • 2 Answers

SOURCE:

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Anonymous

  • 1 Answer

SOURCE: ABS, ESP, Level warning lights (2004 Allroad TDI)

I had the brake light switch replaced by a local dealer. Cost was $140 and it fixed the problem. Have driven the car for two weeks since and no lights and all systems normal.

Posted on Oct 15, 2008

Anonymous

  • 1 Answer

SOURCE: Have an audi a4 1.8T Cabrio. Battery went dead,

I had the exact problem with my A4 2001 1,9 TDI but i just turned the car on, then first turned the steering wheel to the left as far as it goes, then to the right (i dont know if this is necessary but this is what i did). After i drove for few meters,the light went off and it worked normally.

Posted on Oct 04, 2009

miket756

Michael Thorpe

  • 2702 Answers

SOURCE: I have a 2005 Audi A4 2.0 TDi. The battery

the cars cpu? its the cars brain? will need to go onto a computer to find out what the codes are

Posted on Oct 30, 2009

Anonymous

  • 225 Answers

SOURCE: Audi a4 ABS light on

ensure the ecu connection is good the plug for those sometimes need a good amount of pressure to put on abs light i would check the sensors next to your brake caliper to ensure its not broken or disconnect it or if you dont feel like checking it buy new ones and replace them

Posted on Nov 03, 2009

janlinekbmw

Jan Linek BMW

  • 153 Answers

SOURCE: audi a4 2.0tdi [170] engine management light showing.

This part does not repairing!
Pressure sensor is in a before diesel particle filter in exhaust pipe

Posted on Jun 26, 2010

Testimonial: "thanks mate, price one up from dealers monday.thanks great help,wasn't expecting a prompt reply.great"

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How do i reset Air bag code for 2006 mercedes E350


Mercedes SRS Airbag Light MOT FAIL How To Fix - YouTube

? 3:48
https://www.youtube.com/watch?v=JVEuOzYaH1M
Oct 1, 2013 - Uploaded by OBD Diagnostics
Mercedes SRS Airbag Light MOT FAIL How To Fix ... SRS LightReset (cheap, easy) - Duration: 3:07. ... Autel AL619 Clear SRSAirbag Light Mercedes W211 E Class ... OBD2 Fault CodeDiagnostic Scanner/Readers @ Diagnostic World ... 2000Mercedes-Benz CLK-Class Start Up -- SRS Airbag Light On ...

Mercedes E W211 SRS Airbag Warning Light - How to turn it ...

? 1:00
https://www.youtube.com/watch?v=KZWAPGmf-Pk
Feb 12, 2013 - Uploaded by DominatorParts
Mercedes E W211 SRS Airbag Warning Light - How to turn it off ... AUX USB Ipod iPhone adapter E-Class 2003-2008 Mercedes Benz Dension ...

How To Reset The ESP Light On A Mercedes Benz

www.mademan.com/mm/how-reset-esp-light-mercedes-benz.html
Jul 11, 2010 - They will check to see if your Mercedes Benz shoots out any codes. They will check .... How To Reset Airbag Light On A Dodge. Need to know ...

Best tool to reset SRS light - MBWorld.org Forums




Jan 14, 2016 | Cars & Trucks

1 Answer

My esp light has come on and it won't turn off on a Audi a3 2006


TDISLine 1874 solutions Jun 16, 2012
The ESP system means the Electronic Stability Program. If the ESP lights on the dashboard permanently the ESP system is faulty.
You should access the ESP Electronic Control Unit (ECU) memory for pull out all DTC (Diagnostic Trouble Codes), using diagnostic equipment connected to the data link connector of the car. Then you will be full informed about bad pieces (e.g.: brake pedal switch, front right wheel abs sensor interrupted, ...). After bad pieces replacement you will be able to erase all faults memored by ESP ECU, in other words reset the ESP system and turn off the warning lamp on dashboard.

Check & replace if necessary the brake pedal switch placed above pedals on the support.

If the problem still occurs you should access the ABS & ESP ECU (Electronic Control Unit) using diagnostic equipment connected to the data link connector of the car, in order to pull out all DTC (Diagnostic Trouble Codes) memored.
Then you will be able to replace bad piece(s) and fix the problem by erasing all DTC stocked inside ABS & ESP ECU, and reset it.

Jan 09, 2013 | Cars & Trucks

2 Answers

I have an 06 Dodge Magnum. ESP/BAS light


Whenever this warning or any other stays on in the dash it id indicating that the systems control module has detected a fault, it then disables the system as long as the light is on. You must now have the dealer hook up a special electronic diagnostic tool and "scan" the system for the fault code that is stored for the problem(s)

Sep 19, 2012 | 2006 Dodge Magnum

1 Answer

2003 olds alero will not communicate with a scan tool


Start from scratch. Remove key and retry it.

Sep 26, 2017 | 2003 Oldsmobile Alero

1 Answer

The ESP light on my AudiA3 stays on


The ESP system means the Electronic Stability Program. If the ESP lights on the dashboard permanently the ESP system is faulty.
You should access the ESP Electronic Control Unit (ECU) memory for pull out all DTC (Diagnostic Trouble Codes), using diagnostic equipment connected to the data link connector of the car. Then you will be full informed about bad pieces (e.g.: brake pedal switch, front right wheel abs sensor interrupted, ...). After bad pieces replacement you will be able to erase all faults memored by ESP ECU, in other words reset the ESP system and turn off the warning lamp on dashboard.

Check & replace if necessary the brake pedal switch placed above pedals on the support.

If the problem still occurs you should access the ABS & ESP ECU (Electronic Control Unit) using diagnostic equipment connected to the data link connector of the car, in order to pull out all DTC (Diagnostic Trouble Codes) memored.
Then you will be able to replace bad piece(s) and fix the problem by erasing all DTC stocked inside ABS & ESP ECU, and reset it.


tdisline_516.jpg

Jun 16, 2012 | 2006 Audi A3

1 Answer

What does ESP light mean on a cls 500 Mercedes Benz


The ESP system means the Electronic Stability Program. If the ESP lights on the dashboard permanently the ESP system is faulty.
You should access the ESP Electronic Control Unit (ECU) memory for pull out all DTC (Diagnostic Trouble Codes), using diagnostic equipment connected to the data link connector of the car. Then you will be full informed about bad pieces (e.g.: brake pedal switch, front right wheel abs sensor interrupted, ...). After bad pieces replacement you will be able to erase all faults memored by ESP ECU, in other words reset the ESP system and turn off the warning lamp on dashboard.

Check & replace if necessary the brake pedal switch placed above pedals on the support.

If the problem still occurs you should access the ABS & ESP ECU (Electronic Control Unit) using diagnostic equipment connected to the data link connector of the car, in order to pull out all DTC (Diagnostic Trouble Codes) memored.
Then you will be able to replace bad piece(s) and fix the problem by erasing all DTC stocked inside ABS & ESP ECU, and reset it.


tdisline_516.jpg

Feb 10, 2012 | 2006 Mercedes-Benz Mercedes Benz CLS500

1 Answer

Yellow warning indicator lamp of a tringle with an excalmation point in the center and a counterclockwise arrow arround the triangle ---what does it mean?


Check & replace if necessary the brake pedal switch placed above pedals on the support.
If the problem still occurs you might access the ABS & ESP ECU (Electronic Control Unit) using diagnostic equipment connected to the data link connector of the car, in order to pull out all DTC (Diagnostic Trouble Codes) memored.
Then you will be able to replace bad piece(s) and fix the problem by erasing all DTC stocked inside ABS ECU & reset it.
tdisline_516.jpg
The ESP system means the Electronic Stability Program. If the ESP lights on the dashboard permanently the ESP system is faulty. You must access the ESP Electronic Control Unit (ECU) memory for pull out all DTC (Diagnostic Trouble Codes), using diagnostic equipment connected to the data link connector of the car. Then you will be full informed about bad pieces (e.g.: brake pedal switch, front right wheel abs sensor interrupted, ...). After bad pieces replacement you will be able to erase all faults memored by ESP ECU, in other words reset the ESP system and turn off the warning lamp on dashboard.
I'm convinced that your brake pedal switch is faulty because the glow plug warning sign went ON after ESP warning light. Just replace the brake pedal switch, see if rear stop lamps light when press the brake pedal, and test the car on the road.
Good Luck!

Sep 06, 2011 | 2005 Audi A4

1 Answer

I have a vw passat TDI130 2003. It runs really well, but engine workshop lights up along with the esp, abs and the glow plug indicators lighting up, most garages are charging just for a diagnosis to the...


Check & replace if necessary the brake pedal switch placed above pedals on the support.
If the problem still occurs you might access the ESP & ABS ECU (Electronic Control Unit) using diagnostic equipment connected to the data link connector of the car, in order to pull out all DTC (Diagnostic Trouble Codes) memored.
Then you will be able to replace bad piece(s) and fix the problem by erasing all DTC stocked inside ESP & ABS ECU & reset it.
I'm convinced that your brake pedal switch is faulty because the glow plug warning light went ON, along with the ESP & ABS. Just replace the brake pedal switch, see if rear stop lamps light when press the brake pedal, and test the car on the road.

May 20, 2011 | 2003 Volkswagen Passat

1 Answer

I cleaned the battery terminals as I appeared to have trouble with the battery. In disconnecting the ESP/bas , both airbag, slippery surface indicators all stay on and appears computer won't reset...


I'd try bringing it to any of the larger parts stores and ask if they can scan the codes (they usually do that free) After they have finished, ask if they can clear the existing codes. That should turn the warning lights off. The system itself goes through self diagnostics about every fifty miles or so. Likely if you do nothing except for driving it, once the on board diagnostics have self checked, it's likely the lights will go out by themselves.

May 15, 2011 | 2006 Jeep Liberty

1 Answer

The esp light went on first and then the glow plug warning sign on my 2005 TDi passat. said workshop assistance, what is the problem


Check & replace if necessary the brake pedal switch placed above pedals on the support.
If the problem still occurs you might access the ABS & ESP ECU (Electronic Control Unit) using diagnostic equipment connected to the data link connector of the car, in order to pull out all DTC (Diagnostic Trouble Codes) memored.
Then you will be able to replace bad piece(s) and fix the problem by erasing all DTC stocked inside ABS ECU & reset it.
tdisline_516.jpg
The ESP system means the Electronic Stability Program. If the ESP lights on the dashboard permanently the ESP system is faulty. You must access the ESP Electronic Control Unit (ECU) memory for pull out all DTC (Diagnostic Trouble Codes), using diagnostic equipment connected to the data link connector of the car. Then you will be full informed about bad pieces (e.g.: brake pedal switch, front right wheel abs sensor interrupted, ...). After bad pieces replacement you will be able to erase all faults memored by ESP ECU, in other words reset the ESP system and turn off the warning lamp on dashboard.
I'm convinced that your brake pedal switch is faulty because the glow plug warning sign went ON after ESP warning light. Just replace the brake pedal switch, see if rear stop lamps light when press the brake pedal, and test the car on the road.
Good Luck!

May 11, 2011 | 2003 Volkswagen Passat

Not finding what you are looking for?
2004 Audi A3 Sportback Logo

Related Topics:

247 people viewed this question

Ask a Question

Usually answered in minutes!

Top Audi Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22485 Answers

Marvin
Marvin

Level 3 Expert

85222 Answers

Jonah Oneal

Level 3 Expert

14092 Answers

Are you an Audi Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...