SOURCE: volvo s60 abs systems
it is most likely that the abs module is faulty,, if the fault codes are read and it shows a fault with the right rear sensor then the module is faulty,,they usually go wrong at about 110//140k
SOURCE: check engine light code PO442
You likely won't notice any drivability problems. P0442 indicates a fuel vapor leak in the EVAP control system. It means a very small leak has been detected. In fact, the leak can be from a hole as small as 0.04" in diameter.
The (EVAP) emission control system prevents the escape of fuel vapors from a vehicle's fuel system. Fuel vapors are routed by hoses to a charcoal canister for storage.
Later, when the engine is running a purge control valve opens allowing intake vacuum to siphon the fuel vapors into the engine.
With a P0442, the most common repair is to Remove and reinstall the gas cap, clear the codes, and drive for a day and see if the codes come back. Otherwise, replace the gas cap, or Inspect the EVAP system for cuts/holes in tubes/hoses.
Good luck and hope this helps
SOURCE: Volvo S60 sensor ?
Sounds like an oxygen sensor (there are two). I had a recent problem where I had a rough idle and my S60 continued to stall out. Turned out to be the rear oxygen sensor. After replacement, car idles nicely and car drives normally.
SOURCE: I have a 2004 Volvo S60. How can I clear the
Close all doors.Turn ignition key to position 1.PRESS AND HOLD trip reset button,immediately turn ignition to position2,keep trip button held untill trip is reset to 0.A yellow warning light will show when it is time to release trip button.Release within 4seconds ,a bleep will be confirm reset.Before you start reset, do not reset trip,If trip has been reset to 0,turn ignition to position 2 hold reset for 10- 15 secs untill previous reading is shown,then start reset.
163 views
Usually answered in minutes!
×