I HAVE A 2003 DODGE INTREPID IT IS CODING PO700 AND PO871 WHAT DO I DO?
SOURCE: Having trouble with my transmision in my dodge
Here's what my service manual says:
EATX Controller DTC Present
This SBEC III or JTEC DTC indicates that the EATX or Aisin controller has an active fault and has illuminated the MIL via a CCD (EATX) or SCI (Aisin) message. The spscific fault must be acquired from the EATX via CCD or from the Aisin via ISO-9141.
Here's what I know: MIL=malfunction indicator light; DTC=diganostic trouble code; CCD=Chrysler collision detection. Beyond that, I'm clueless. Sounds like it needs to be read out at the dealer. Then again, if it was a one-time glitch, it might clear itself after several drive cycles.
SOURCE: 2002 Dodge Intrepid- check engine light came on
This code indicates an automatic transmission control problem. The presence of this code means that the transmission control module or TCM has detected a fault and relayed it to the PCM. It could be a TCM related solenoid has failed or is damaged or the TCM itself could be faulty. Best wishes.
SOURCE: Chrysler intrepid 2003 obd 2 code P0441
Most common problem causing this code is the purge solenoid. A quick smoke test will show if you have any leaks in the system. If no leaks and the fuel cap is installed properly it's the purge solenoid.
SOURCE: I have a 2002 Dodge Intrepid 2.7L and ran the
Try removing the negitive cable from the battery for 5 minutes. Hook it back up and start the car. Let it warm up and then drive it normally for 2 or 3 miles. Then recheck for the codes.
428 views
Usually answered in minutes!
×