What size low beam light do i need for a 2011 jetta

SOURCE: replace low beam bulb in 2005 jetta

1. Open the vehicle's hood and secure it in an upright position.
2. Disconnect the negative battery cable.
3. Remove the socket cover by pulling it straight off, or turning it clockwise then pulling it off.
4. Carefully twist the bulb and socket counterclockwise, then pull the assembly from the headlight housing.
5. Holding the base of the bulb, detach it from the connector harness.

1. Holding the base of the bulb, install it securely in the connector.
2. Install the connector and bulb assembly in the housing and twist to lock into position.
3. Install the sealing cover by pushing it on and/or turning it counterclockwise. Make sure the cover is installed securely or the lens will be out of focus, or water may get into the light unit.
4. Disconnect the negative battery cable and check the headlight operation.

SOURCE: no low beams on my 2002 jetta

first check the wire make sure low beam power is there if there is power check your low beam fuse if fuse is good check the rely and if that good check head light module make its putting out power and if all that is goo then change you bulb it may be a double filament buld and the low beam side is blown

SOURCE: left head light on low beam does not come on

check the headlight fuse.has one for low and one for high beams

SOURCE: front end light adjustments

The adjustment screws/nuts should be located either on the top of the headlamp assembly, behind the headlamp assembly, or near the frame rail by the radiator support.

You will have vertical adjustment screws for each independent beam (separate highs and separate lows, but will be same screw if highs and lows are the same bulb). You may also have additional horizontal adjustment screws as well

Park your car on a level ground 30 feet from a wall and measure the height from the ground to the bulb and mark on a wall (do this for highs beams and low beams if the bulbs are separate, if highs and lows are the same bulb, only do it for the lows)

For Low Beams: If the headlights read VOR, then aim the brightest part or cutoff part just below the mark on the wall. If it says VOL or nothing, aim them 2 inches below the mark on the wall.

For High Beams (if separate from low beams): Aim the headlight directly at the line you marked on the wall.

SOURCE: i need to no what fuse runs my low beams in a 98

Try fuse S20, S21 in relay plate fuse box.