1991 Chevrolet Camaro Logo

Related Topics:

A
Anonymous Posted on Jul 15, 2014

Why does my camaro stall between 600 and 1000 rpm

Stalls when stopped in gear. Stall range is from 600 to 1000 rpm. Have had tps replaced

  •  Stephen
    Stephen Jul 15, 2014

    Hi Anonymous, does it stall in reverse and park, or just in drive ?

×

1 Answer

maximus3319

Level 2:

An expert who has achieved level 2 by getting 100 points

MVP:

An expert that got 5 achievements.

New Friend:

An expert that has 1 follower.

Cheetah:

An expert who has answered 20 or more questions within one hour.

  • Expert 120 Answers
  • Posted on Apr 01, 2015
maximus3319
Expert
Level 2:

An expert who has achieved level 2 by getting 100 points

MVP:

An expert that got 5 achievements.

New Friend:

An expert that has 1 follower.

Cheetah:

An expert who has answered 20 or more questions within one hour.

Joined: Jan 23, 2009
Answers
120
Questions
0
Helped
19190
Points
279

I had an 86 that used to do that all the time and I replaced the starter and then it worked fine

5 Related Answers

Anonymous

  • 88 Answers
  • Posted on May 23, 2009

SOURCE: Stalls when placed in reverse

well you have convertor lock prob prob a sensor for trans let me know hey till fix ya bouy me ok

Ad

Anonymous

  • 13 Answers
  • Posted on Jun 26, 2009

SOURCE: car will stall whenver i drive a lot of stop and go stalls at lig

TCC Solenoid. Its locking up. Torque Converter Clutch Solenoid. Its a minor transmission issue. Have the same problem with my car.

Anonymous

  • 6982 Answers
  • Posted on Sep 03, 2009

SOURCE: 95 impala lt1 will stall when warm and not start

On the plus side, when you are finished, you will have a new control system! On the negative side, you just spent more money on parts than if you'd have just taken it to a dealer! I hope you tested those components and determined they have failed. Any codes?
Seems like the only thing you missed is the coil and the temp sending unit (just for laughs, unplug it and see if it stalls out at the same time), or possibly a security system malfunction. Get a decent volt/ohmeter and a vehicle specific manual such as chiltons or haynes. Do some testing, hot and cold and compare your results.You need to determine what is shutting down (fuel, spark or both) Once you develop a "picture" regarding what is happening, you will be more able to find a solution. I can't give you a "fix" on this one only because to properly identify the problem, I'd need to do the same testing I suggested.
good luck

Anonymous

  • 4669 Answers
  • Posted on Jun 22, 2010

SOURCE: 1991 Chevy Caprice has a mild miss fire and stall

Do you have the idle speed turned up to keep it from dying? Because it is high. Check engine light on? Have you checked for vacuum leaks at the gasket under the throttle body? How does the car run under acceleration? You might have a worn distributor shaft.

Testimonial: "Thank you for your tips and ideas you have gave me, One question, but before read my latest update. my car rpms hover around in between 1100 to 1500rpm at idle, but when I shift into drive it goes to a steady 1000rpm... is that good? if not, what are the correct specs. thanks again"

Anonymous

  • 1 Answer
  • Posted on Oct 01, 2011

SOURCE: 06 COBALT STALLS WHEN I STOP AHHHHHHHHHHHH

Easy fix... Take a gallon of gas and a clean cloth or shirt. Soak the cloth in the gas and wipe all the interior down with the gas.

Then poor some of the gas all over the engine, making sure to soak it really good

After doing this, take a match and burn that f**ker..
Mine was doing the same thing, I burned it and blamed it on Islamic jihad to my insurance. Never looked back

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
2answers

Will a bad shift solenoid cause a 1996 ford f150 to stall in reverse

Your torque convertor will stop the engine stalling.
0helpful
1answer
0helpful
1answer

Every time my car comes to a red light it powers off.why?

EGR (exhaust gas recirculation),or TPS (throttle position sensor) When the vehicle makes a stop and go into idle. The RPM is basically too low to maintain the RPM, If the vehicle runs 800 RPM in park or neutral and doesnt stall the setting is correct. If it stall in neutral or park and has a hard time accelerating you will need a TPS, The EGR can stall a engine if it stays open underload approching a stop where it doesnt close properly
2helpful
1answer

95 KIA SPORTAGE 4X4 NOT GETTING FUEL

You replaced TPS. It starts and stall, If you can keep a high steady RPM and it not stall out.Then its not a fuel issue. But stall at idle and not at load.On the throttle body is a Idle air control valve (IAC) your year make and model are popular for the inside passage to be restricted or even blocked clean out the passage.You may even need a IAC
1helpful
2answers

1991 Chevy Caprice has a mild miss fire and stall at low rpm: This is my latest update: I checked and cleaned the EGR,PCV,IAC valve, M.A.P sensor and Throttle body(bore/butterfly). with carb cleaner....

Do you have the idle speed turned up to keep it from dying? Because it is high. Check engine light on? Have you checked for vacuum leaks at the gasket under the throttle body? How does the car run under acceleration? You might have a worn distributor shaft.
0helpful
1answer

2001 dodge dakota stalling when coming to a stop

While driving, the Idle air control valve (IAC) fully retracts and you control airflow with the gas pedal. When you come to a stop the computer extends the IAC to let air bypass the throttle plate and maintain idle speed. If the IAC is sticking it sometimes cannot compensate fast enough to avoid a stall. The problem is aggravated by the Air conditioner clutch cycling on while stopping. You don't mention the check engine light so not likely a sensor. If you have a OBDII scanner with live data available you can check the Throttle position sensor easily. You are looking for a smooth change through the range as you press and release the gas pedal. Or use a voltmeter to see the TPS. Measure resistance with engine off or voltage (0 to 5 volts) with ignition on. It should move smoothly through the range.
Another easy test. Park brake on, in gear (if an automatic transmission) at idle, load the engine by turning the steering quickly to the end and see how quickly the IAC recovers. Clean or replace IAC and while in there clean the carbon off of the edges of the throttle plate.
0helpful
1answer

2001 Pontiac Grand Prix... 3.8 ltr stalling when in gear stopped

Try replacing PCV valve on the valve cover-had same problem one time on a 3100 I had.
0helpful
2answers

Jeep wrangler stalls out

check maf and tps sensor
3helpful
3answers

Rough idle stalls at low rpm's

check your transmission fluid,the motor will stall when fluid is low
0helpful
1answer

Rough idle/stall

i would start with the TPS ( throttle positioning sensor ).
Not finding what you are looking for?

101 views

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

john h

Level 3 Expert

29494 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...