Location of inertia switch

Question edited for clarity.
Question moved to model category.

Information here on the forum

how do i do the throttle body relearn procedure???

My350z https://my350z.com > ... > Maintenance & Repair
Jul 7, 2008 - Try this: Disconnect accelerator pedal position sensor. Wait 30 seconds and then reconnect. Disconnect electric throttle control actuator. Wait ...

Re-programming throttle body - MY350Z.COM
Apr 13, 2004
Idle relearn is not working! - MY350Z.COM
Apr 14, 2017
Official ECU reset procedure - MY350Z.COM
Apr 14, 2017
Accelerator Pedal Position Sensor - MY350Z.COM
Apr 14, 2017
More results from my350z.com Try this

350z Reset proceedure (Pedal Dance)

Horsham Developments https://h-dev.co.uk > 350z-reset-proceedure-pedal-dance
Turn ignition switch OFF and wait at least 10 seconds. Make sure that throttle valve moves during above 10 seconds by confirming the operating sound. Idle Air ...

1. Locate your car's inertial trigger or airbag control module. ...
2. Push the button on the inertial switch; it should be clearly marked as the fuel pump reset, and may be in a contrasting color to the case. ...
3. Remove the inertia switch cover by either prying the plastic clips loose or removing the screws that hold it in place.
4. https://www.youtube.com/watch?v=YXFujJXrscg

Many vehicles available today come with fuel pump shut-off switches. These devices are essentially circuit breakers that sit inside you car's airbag control module's inertia switch, which is supposed to trigger when the vehicle comes to a sudden stop. This safety feature is intended to shut the fuel pump off in the event of an accident, but can sometimes be triggered by a pothole or even by sudden brake application. These switches are generally designed for a quick reset, but some models may require a more involved approach. Locate your car's inertial trigger or airbag control module. You owner's manual should give the exact location, but if it doesn't try looking inside the center console, under the front seats, behind the glove compartment or behind the driver or passenger-side kick panels. These are the trim pieces just ahead of your front doors where your foot typically brushes. Push the button on the inertial switch; it should be clearly marked as the fuel pump reset, and may be in a contrasting color to the case. You may need to turn the ignition key to the on or accessory position to energize the module and reset the switch. Proceed to the next step if your inertia switch doesn't use an external button. Remove the inertia switch cover by either prying the plastic clips loose or removing the screws that hold it in place. Inside the switch you'll see one of three things: a button, a circuit-breaker-type switch or a fuse. Push the button or flip the breaker switch back to its original position. If your inertia switch uses an internal fuse, pull the blown fuse out and replace it with another fuse of the same rating

Hi James,here's what the sensor look's like. 5results for 2004 nissan 350z throttle position sensor .it's in the throttle body.

click on link to see. Nissian Crankshaft and Camshaft Sensor Recall Nissan 350Z Common Engine...

not equiped

The inertial cut-off switch is located in the Ford parked Nextel to it.

350z's have electronic tilting wing mirrors with an on/off position for reverse gear. Some people don't want the mirrors to be adjustable while backing so Nissan put an optional switch on them for enable/disable while the shifter is in reverse position. That is how the car came from the factory. Not sure where that switch is located.

there is an after run module controlled by a fan switch that will run the fan if the engine compartment is hot.the switch could be shorted,or the module is bad.the fan normally runs for a few minutes then turns off.

one under the hood and one at the drivers kick panel