How to replace actuator on 2001 ford windstar mini van
Remove the door panel then remove the door latch and actuator
The blender door actuator, the one that most commonly fails on Windstars, is located behind the radio. Remove the radio to gain access. Is white.
SOURCE: change oxygen sensor 2001 ford windstar
fist unclip wire,then unscrew it with a 28mm spanner ,fitting procedure is the reverse .It turns anticlockwise to unscrew and clockwise to screw up ,torque setting is a grunt and two scuffed knuckles and max of 3 swear words
SOURCE: I have a 2001 Ford
could be the anti theft. try turning the key backwards. then try to start it.
SOURCE: NO heat in front of 2001 windstar van. Thumping
Blend air door may be stuck. I removed a pencil from a heater box before. It had fallen from the dash, down through the defrost vents and jamed the door.
SOURCE: 2001 Ford Windstar van seems to skip when you push
It may be due to plugs, fuel filter, fuel pump, or mass airflow sensor. Is your check engine light on?
SOURCE: 1999 ford windstar.
replace VSS (speed sensor) and/or TRS (range sensor) use a DTC reader to confirm
210 views
Usually answered in minutes!
×