2003 Chevrolet Suburban 1500 Logo

Related Topics:

A
Anonymous Posted on Jul 11, 2014

Why tachometer quit working while driving on bumpy road got erratic then quit working at all 2005 z71 suburban

3 Related Answers

Anonymous

  • 16 Answers
  • Posted on May 08, 2009

SOURCE: When driving my oil pressure gauge and tachometer does not work

if its not a fuse check the speed sensor for the tach, and the oil pressure switch on the side of the engine block see if the lead came loose

Ad

Anonymous

  • 520 Answers
  • Posted on Jun 05, 2009

SOURCE: clutch on compressor will work sometime than quit

There is no interrupter switch on the a/c system. The only reasons that the clutch wouldn't engage is
1.- there is a short in wire to clutch
2.- the freon level is to low
3.- the low side pressure switch has failed
4.- the compressor clutch is going out
Hope this helps you get this problem taken care of. Good luck.

ejwfix

  • 179 Answers
  • Posted on Dec 29, 2010

SOURCE: What to do since my

You will need to bring it to a dealer or tire service center to see what the problem is.Most of the time it will be a sensor.Sometimes they can be just relearned.Also you may want to check your tire pressures.Make sure they are pressurized to what the pressure says on your door placard.

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer

My Infiniti 2005 qx56 rpm stopped working please advise thanks

https://www.clubarmada.com/threads/erratic-tachometer.17405/
This thread has several suggestions from a failing battery to bad grounds or BCM problems.
1helpful
1answer

I have a 1998 GMC Suburban that pops out of gear sometimes I have to put in four wheel drive then back into 2 wheel drive then it fixes itself. I had the tranny and transfer case rebuilt but it still does...

Sounds like your talking about a transfer case problem,
need to have the truck to look over ,test,road test etc
Can't do anything from here,without the patient
0helpful
1answer

2005 suburban 5.3 engine where are knock sensors located and how do you replace them

two knock sensors.under phlemm assy. replace cover gasket, two sensors and wire harness.
0helpful
1answer

Power loss in accelerator pedal

looks like something either is loose or not well connected. revise the job you have done step by step and I believe you will come across with the fault.
0helpful
1answer

2005 Nissan Xterra Shaking Problems.HELP?

each one of the cylinders have there own seperate coil, if cylinder 5 is misfiring then the coil is bad. One cylinder not firing will cause the vehicle to run really rough hope this is helpful
0helpful
1answer

2005 Buick LeSabre tachometer not responding when engine is running. Tachometer stays on "0" when enige is running. Slight movement as acceleration increases; however needle barely moves as...

2005 BUICK LESABRE TACHOMETER DOES NOT REGISTER WHEN ENGINE IS RUNNING. SOMETIMES IT BARELY MOVES, THEN GOES BACK TO 0
SAME CAR HAD SPEEDOMETER QUIT, REPLACED WITH NEW SENSOR, DROVE ABOUT 1300 MILES AND IT QUIT AGAIN. CLEANED THE SENSOR, WORKS OK NOW.
0helpful
1answer

Buick shakes, guns then almost stops

this sounds very much like a torque converter/transmission issue. i will assume the transmission dial you're speaking of is the tachometer? which measures engine revolutions per minute. to confirm, one could possibly unplug 4-wire connector on transmission near radiator and test drive. this keeps the transmission from going into torque converter lock-up.
Not finding what you are looking for?

127 views

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6988 Answers

john h

Level 3 Expert

29494 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...