I can not get the steering gear to go back onto the steering wheel help/

SOURCE: RACK AND PINON DODGE RAM 1500 2005

if you have a leak from the back of the rack your sector shaft seal is defective. to replace it you need to remove the rack and do it on the bench.remove the locking nut and pull the seal from inside.if you are a rooky replace the rack with a rebuild one. good luck.

SOURCE: rack & pinion replacement

there many web sites that offer tech suppurt, even Chrysler, just start looking, also Napa Auto Parts. Auto Zone. This is to hard to explain on a site like this. GOOD LUCK RDJRP

Dana Newcombe

• 1564 Answers
• Posted on Sep 07, 2009

SOURCE: how do i remove and replace the rack and pinion

You may very well not be able to do this job unless you have a lift. You're going to have to remove the lines that hide up on top and under other crossing lines. Plus the bolts that actually mount the rack are about an inch in diameter if not more and they are fine thread. I think it would be to your best advantage to have this done at a shop by a proffesional. It will save you a lot of grey hairs in the future.

Testimonial: "i know its hard! i just need to know if i can remove frame crash support without any problems."

SOURCE: 2005 Dodge Grand caravan- After Rack & Pinion

The dummy that did the rack broke your clock spring.

Josh

• 122 Answers
• Posted on Apr 20, 2010

SOURCE: 2005 dodge caravan, leaking power steering

I really wouldn't push it more than 3 months or especially if climate change once the leak stop has stopped the leak it doesn't like temp change. but i've done radiator stop leak from Lucas and went 6 months before the leak appeared again. good luck