I NEED TO REPLACE THE DRIVERS SEAT BELT IN MY C180...I DO NOT KNOW HOW TO TAKE THE B-PILLAR TRIM OFF AS I DONT KNOW IF THERE ARE TORX SCREWS OR JUST RETAINER CLIPS HOLDING IT ON....I NEED TO GET THEM OFF WITHOUT SNAPPING OR BREAKING ANY OF THEM...ANY HELP OR ADVICE WOULD BE GRATEFULLY APPRECIATED...CHEERS...EDDIE
SOURCE: front brake pad removal '89 nissan sunny
Dear Customer ,
Company had design that retaining clips for high performance at high speed so dont do that cause if you will remove its will look like comfartable but its may be risky.
so,do with care.
SOURCE: Seat Belt repair/replace
SOURCE: 2002 maxima belt replacement
You will need to gain access behind the inner splash shield to get to your belts. This is relatively simple. It is helpful, also, if you can jack the front of the car up and take the Right Front wheel off and get it out of your way.
The splash shield is held on by plastic push pins that are easy to remove with a small flat head screwdriver by prying behind the head of the center section of the clip.
This should give you easy access to your belts.
Hope this is helpful!!
Nissan Scope Technician- 10+ years experience in Nissan dealership.
SOURCE: 1993 nissan 300zx door panel removal to fix lock
Its tricky but you need to pop the half circle off to get to the 14mm bolt. Then roll the window down and there is a plastic circle at the top of the door frame. Pop that off and remove the one plillips screw and pop the panel off to get to the remaining 2 10mm bolts holding the door panel on.
Removal & Installation
j. On long wheelbase wagons only, remove the quarter trim from the quarter panel and pull second rear seat belt through access hole.
k. Pull first rear seat belt through the access hole.
l. Remove the quarter trim panel from the vehicle.
3. Remove the 5 screws mounting the A/C-heater blower motor housing to the rear HVAC unit (one mounting screw located on evaporator cover).
4. Twist the blower motor out of scroll housing.
5. Disconnect the blower motor wiring connector.
6. Remove the blower motor from vehicle.
Fig. The rear blower motor is held in place by four screws
To install:
Fig. Removing the trim panel to access the rear blower motor
Fig. The rear blower motor is held in place by four screws
45 views
Usually answered in minutes!
×