Cruise control does not work. what is fuse location
Begin with consulting your owners manual for fuse box 'legend'....
If you need further help, reach me via phone at https://www.6ya.com/expert/ralph_2f0886b7d6af32ce
SOURCE: cruise control
Here's the situation, there was a factory recall on the cruise control module for Explorers and Expeditions during recent years and your vehicle may be included. This is very important because in some vehicles this faulty cruise control module sparked and caught on fire. Here's what you do, call the Ford dealer in your area(service) with the vin number to your vehicle, they will tell you if your vehicle was under this factory recall and if it is they will replace it for free. I would be very careful as you may have one of these faulty modules. Hope this helped.
SOURCE: 2002 F250 Cruise Control and Washer Fluid pump don't work
I looked at the owner's manual (starting at pg 162) at the fuse block and it does not mention either of those two particular functions as they relate to a specific fuse. I would recommend you get a tester and check all the fuses to be sure. Good luck! Oh yeah, you can get a copy of the owners manual in PDF format by going to MotorCraftService.com
SOURCE: cruise control does not function
cruise on a ford escort?? not fitted to europeon model thats for sure.All fuses are in the fuse box above left knee ,unhook the fuse box and let it drop to get at relays.
SOURCE: cruise control will not turn on. light on dash use
Did you have the recall for the cruise control done ?
recall 05S28. Description: Speed Control Deactivation Switch.
It could be the fuse in the recall harness is blown.
Try the Cruise Control Self test :
----------------------------------
Self-Test Diagnostics
WARNING:
This test is a key on engine off (KOEO) test only that is conducted in park only with emergency brake fully engaged.
1. Enter self-test diagnostics by depressing the speed control OFF switch while turning the ignition key ON, making sure the engine does not start and is not running. The speed control indicator on the instrument panel will flash once to indicate that speed control module entered the diagnostic mode. Five additional flashes at this point indicate a defective speed control servo. Release the OFF switch.
2. Press the remaining switches in this sequence: ON, RESUME, COAST and SET/ACCEL.
If the ON switch is not depressed within five seconds after entering the diagnostics mode, the module times out and the procedure must be started over.
The speed control indicator lamp will flash as each switch is depressed. Press each switch in the sequence immediately after the indicator light goes out for the previous switch.
Note:
There will be a slight delay when the last button is pressed and the lamp flashes.
3. A lamp flash with the last button (SET/ACCEL) indicates that the static test passed. If the lamp does not flash with the last button and there are no additional flashes of the lamp, the switch is defective.
If the lamp does not flash with the last button, and additional flashes occur, follow the chart below for trouble codes:
— 2 flashes - BPP defective, circuit is defective, brake applied, CPP switch or jumper (if equipped).
— 3 flashes - deactivator switch is open or circuit defective.
— 4 flashes - vehicle speed signal is out of range or circuit is defective
4. Immediately (.25 second delay) after the static test, the speed control servo does a dynamic test by automatically actuating the throttle lever from 8 mm (0.315 in) to 12 mm (0.472 in) of travel from the idle position. During the dynamic throttle pull, observe throttle movement to witness any binding or sticking of the speed control cable and correct connection of speed control cable to throttle lever. Make sure the throttle returns to the idle position.
5. Return the ignition switch to the OFF position and proceed to the Symptom Chart.
----------------------------
If the Cruise Control does not enter self test, the fuse in the recall harness ( if done ) is most likely blown and needs to be replaced.
Testimonial: "thank you very much"
SOURCE: Where's the cruise control fuse located on a 2002
Check the Central Junction Box and this diagrams; also can check this in your 2002-Ford-Excursion owners manual.
Fig. Vehicle Speed Control, Page 01 (2002, System overview,
Gasoline engines)
Fig. Vehicle Speed Control, Page 02 (2002, System overview, Diesel
only)
Fig. Vehicle Speed Control, Page 03 (2002, Gasoline engines)
Fig. Vehicle Speed Control, Page 04 (2002, Gasoline engines)
Fig. Vehicle Speed Control, Page 05 (2002, Diesel only)
Good luck.
184 views
Usually answered in minutes!
×