At Fixya.com, our trusted experts are meticulously vetted and possess extensive experience in their respective fields. Backed by a community of knowledgeable professionals, our platform ensures that the solutions provided are thoroughly researched and validated.
Re: Are 08 hyundai santa fe and tucson desame stereo...
NOPE! . Go to http://www.hmaservice.com/ and register (vehicle by VIN). Afterward, you'll have access to technical information (manuals, wiring diagrams, service bulletins, etc) about your vehicle.
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
I am a mechanic ..most people ask questions about these foreign hyundai motors ..below is an example of engines that basically if you ask about a Hyundai Xg 350 ,xg300 ..well allow me to hammer 90% of your questions in case you want to grab another motor ..these motors listed will work on 90% of all hyundai products ...Look at the starter sizes ,,all the same for the selected models ..then look at the motor sizes ..This will help you in solving some problems most do not give the specific questioning 100% NEW REPLACEMENT STARTER FOR STARTER
HYUNDAI 2001 SANTA FE 2.7L ENGINE 2002 SANTA FE 2.7L ENGINE 2003 SANTA FE 2.7L ENGINE 2004 SANTA FE 2.7L ENGINE 2005 SANTA FE 2.7L ENGINE 2006 SANTA FE 2.7L ENGINE
2003 SANTA FE 3.5L ENGINE 2004 SANTA FE 3.5L ENGINE 2005 SANTA FE 3.5L ENGINE 2006 SANTA FE 3.5L ENGINE
The camshaft position sensor on the 2005 Hyundai Santa Fe 3.5L V6 is located on the side of the engine block, just below the ignition coil packs. It is held in place with a single 10mm bolt. To replace it, you must remove the bolt and then unplug the wiring harness. Once the old sensor is removed, replace it with a new one and plug the wiring harness back in. Finally, reinstall the 10mm bolt and tighten it securely.
Suggest obtain the shop manual for your model and turn to the wiring diagram pages.
If you still have problems, find a 12 volt circuit and use that to splice in your aftermarket stereo. Be sure the circuit is through your ignition/accessories switch. Also be sure to use an in-line fuse to prevent shorting issues.
In worst case scenario you can inspect the back of your speakers and find the color of the wires and use that info to connect your aftermarket stereo. Be sure that the impedance of your speakers matches the wattage and impedance of your aftermarket stereo. A good volt/ohm meter is handy for this task. Good luck.
The pink wire from the stereo unit is often the dimmer wire, and is connected to a power feed from the vehicle's side lights. Not all stereos have a dimmer function however, and may not have this wire available.
2 bolts in each of the seats' floor rails... total of 8. Wire harness connectors may not be the same power seat control harness, seat heaters, etc. Research of connectors shows floor harness connectors are identical between 04 & 05. However, optional features like seat warmers in the wire harness of the 05 model may not exist in the other and vise versa.
×