Question about 2007 Jeep Liberty Sport

1 Answer

My dash lights and console lights went out

When I added a trailer to my Jeep and tried to hook lights up the dash went out

Posted by Anonymous on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Jeep Master
  • 5,440 Answers

Check fuses.

Posted on May 05, 2015

Ad

3 Suggested Answers

6ya6ya

6ya staff

  • 2 Answers

SOURCE:

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Anonymous

  • 1 Answer

SOURCE: Jeep 2008 unlimted trailer wiring

http://www.etrailer.com/instructions.aspx?pn=118416

Also MOPAR has a similar wiring solution
take a look at the instructions --the visual description is better in the MOPAR manual
http://www.quadratec.com/Assets/Installation/75396.pdf

Posted on Nov 06, 2008

jimsplace60

  • 4 Answers

SOURCE: No dash lights 1995 Jeep.

Look for fuse panel under or either side of dash. Another location may be similar in engine bay.
Fuses probably labelled. Available at motor shops, garages etc.
If out of your experience then probably not expensive to ask auto electrician where to look. Many are cooperative and may tell over the phone or counter.

Posted on May 01, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Cant get running lights to work on trailer


you need a ground wire also..add a ground and it should work.. trailer wiring is like this..white/ground..brown/tail..yellow/brake..and two greens a lighter one for left signal and a darker one for right.. find each one seperately on the jeep because these colors wont match it..and hook them up independently before taping the whole thing up..be checking and adding heavier fuses like 25 or 30 amp due to the extra wire load..

Dec 25, 2013 | Jeep Cherokee Cars & Trucks

1 Answer

Tail lights,dash lights,hazard lights not going,fuses all good.was wiring up a trailer when this fault occured


you probabaly over loaded the curcuit board or you hook the wrong wrie and it went in a safe mode to keep from blowing a fuse

Sep 10, 2012 | Mitsubishi Pajero Cars & Trucks

1 Answer

Brake lights stay on


Check the switch on the pedal up under the dash it may have went bad outside of that you need to figure out where the wires may have got messed up such as trailer plug in if it has one and so on.

Aug 11, 2012 | Jeep Grand Cherokee Cars & Trucks

1 Answer

2005 Jeep Wrangler Unlimited 4x4 Light Problem


You checked to make sure you didn't blow all the bulbs at once?
If your front park lights work, then the headlight switch is probably alright.
You may have a taillight relay in your fusebox. Check the owner's manual. It may show it.

Nov 24, 2011 | 2005 Jeep Wrangler

1 Answer

1999 jeep cherokee-hooked up to a trailer with electrical problem-I instantly lost dim headlight and both driver's side running lights. I suspect the running lights module. I found the replacement part...


Hi. The trailer has a shot in the wiring and blew your Jeep lights. Check for fuse in fuse box near battery or inside Jeep under dash and replace it.

Jun 15, 2011 | 1999 Jeep Cherokee

1 Answer

Went in the ditch and now the tail lights and dash lights don't work. Changed out fuse and now brake lights work but others still don't Any advice?


you are going to have to get under it and start looking for ripped wires or damaged wires. also check around your trailer hook ups. dont know what type of ditch you hit or how you went in or how it was pulled out. if you went through some sapling trees or brush you could have torn up wires. if you blew a fuse then you had to short out wires. if tail went in first then trailer connector is a good place to start.

Feb 06, 2011 | 2000 Ford F350 Super Duty Super Cab

1 Answer

Directional lights and marker lights and dash and radio all come on with brake lights


You have a bad ground wire problem somewhere. The hot wire to the brake lights is back feeding into the other wires. My be in the taillights. I have seen people install a trailer light hook up plug and wire it wrong also that will make this happen. Good luck!

Mar 01, 2010 | 2004 Jeep Wrangler

2 Answers

When I hook up my trailer to my 1996 4Runner both turn signal lights come on at the same time. When we unplug the trailer and connect two lights directly to the factory trailer wires on the rear of...


You likely need diode isolators on the turn signal wiring on the trailer, or on vehicle side connector. Your local auto parts store should have what you need, and show you how to install them.

Aug 25, 2009 | 1996 Toyota 4Runner

Not finding what you are looking for?
2007 Jeep Liberty Sport Logo

Related Topics:

84 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jeep Experts

Marvin
Marvin

Level 3 Expert

85222 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22485 Answers

Jonah Oneal

Level 3 Expert

14092 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...