2003 Nissan Frontier Crew Cab Logo

Related Topics:

A
Anonymous Posted on Jul 05, 2014

Where is the blower motor resistor located on a 2003 Nissan Frontier

5 Related Answers

Anonymous

  • 10 Answers
  • Posted on May 29, 2008

SOURCE: Nissan Frontier torsion bar replacement

well it depends how you want to adjust it, if you want to lower it, back out the screw on the torsion key a couple of turns. raise, screw it in a couple of turns

Ad

Anonymous

  • 45 Answers
  • Posted on Aug 28, 2008

SOURCE: 2004 Nissan Altima Blower Resistor

there is a blower resistor located near blower motor and housing under glove box area it is one connector with about 5 wires to it and looks thin, held by two screws this resistor controls fan speeds - possibly it will look burned may even be hot to the touch so be carefully it is the most probable cause since you obviously have power to it and ground only being the fan speeds the problem.

Anonymous

  • 3 Answers
  • Posted on Apr 13, 2009

SOURCE: fuel filter location

No, it is in front of the fuel tank right behind the tranny crossmember support somewhat hidden by a metal cover. Easy to see if you just look near the middle of the truck - under the where a back seat would be if you have the 4-door model.

Anonymous

  • 82 Answers
  • Posted on Apr 19, 2009

SOURCE: AC blower motor resistor Nissan Maxima 2000

yeh its located under the passenger side glove box,its in the heater box beside the heater motor ,,2 scews hold it in and it looks like a credit card when its out,,,,

emissionwiz

Marvin

  • 85242 Answers
  • Posted on Oct 30, 2009

SOURCE: Where is the knock sensor located on a 2003 nissan

It is located on the engine block itself in the valley between the cylinder heads. The entire intake manifold has to come off to access it:

Testimonial: "I am well satisfied with the quick response and information. Chuck"

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer

Where is the blower motor relay on the 2003 nissan maxima located

Here's a link to what they look like,it's mounted with 2 screws next to the blower motor,easy as pie to remove. Heater Blower Motor Resistor 2003 Nissan Datsun Maxima 6 Cylinders 3 5L...
0helpful
1answer
0helpful
1answer

I can't seem to locate the blower motor resistor for my 2005 Nissan quest.can you help me?

normally in the blower motor enclosure as it uses air flow to help cool the resistors
0helpful
1answer

My 99 nissan frontier blower speeds work on 1,2,3 but, not on 4 . Any solutions?

usually its the heater fan resistor that is bad. it controls the fan speeds for blower motor. The blower motor is mounted under the glove box. It is in the corner somewhat covered by the kick panel. The card, at least on my pathfinder, is held in with 2 phillips head screws. The plug has 4 wires, one large wire and 3 smaller wires. You should see it very near to and parallel with the firewall.

The card has an on board fuse that is not replaceable. It is located on the passenger side fire wall to the left of the blower moter under the glove box. Held in with two silver phillps screws
0helpful
1answer

Blower motor

Not the fuse or it would not work at all,change the resistor.
1helpful
1answer

98 frontier has only high fan setiing that works

Check /replace the blower motor speed control resistor pack - usually located in the blower fan ducting - in the air flow.
0helpful
1answer

Blower or fan runs on high speed, only on no. 4 setting.

on the duct work near the fan... two screws usually hold it in.

Robert
Not finding what you are looking for?

225 views

Ask a Question

Usually answered in minutes!

Top Nissan Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6988 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...