What are all engine torx settings peugeot 206 1.4

there's a website reliable-store
all heavy equipment repair issues servicing, loading, wiring, engine problems everything is covered here its a must try for those who aren't fully equipped with tools or knowledge

Get your engine code and search internet by engine code.

Faulty relay maybe?

@Kenneth Ella: In my Peugeot 206 1.4 (TU engine series), tightening the thermostat housing bolts with a torque 20 nm was the breaking of the thread in the engine head. I think, correct torque is about 10 nm (8-12 nm).

try this:

The cooling fan on the peugeot 206 is situated between the front grille and ththe radiator, To gail access to the fan you first need to remove the 4 push/pin fixings that hold the upper grille panel ,then remove the 2 torx screws from either end of the upper panel (one at each end. Next the lower grille panel needs to be removed by disengaging each end from just below the headlights, these ends are held in place by clips ,and care must be taken when pulling the lower grill from these clips.Once you have both upper and liwer grille removed ,it a simple matter of unplugging the fan connector ,and removing the 3 fixing bolts , the fan can then be removed ,

did you connect the earth strap from the engine to the body ???

Freeze plug, head gasket, hose to the heater core. You have to get back there and look.

hallo
If you have normal 1.6 liter 206:
max bolt lenght:176,5mm
20Nm and aditional 240°

1,6 liter 16valve engine
max bolt lenght:122,6mm
20Nm and aditional 260°

Marko

IF THIS IS NOT A SURPENTINE BELT,TRY THE P/S BELT TO SEE IF ITS LOOSE