Helo a replaed my computer and cat2 model but my car wont start pls help
SOURCE: Battery drained completely BMW E90 2005 model
Connect your old battery with another battery from another car (WHILE KEEPING ALL CABLES CONNECTED ON BOTH CARS) just user a bridge cable otherwise you'll need. a code to reactivate your BMW again. Try now to start your BMW engine. Now go to the nearest battery dealer to change the battery WHILE KEEPING YOUR ENGINE ON, otherwise you'll need a code to activate your BMW again :)
Good Luck!
SOURCE: BMW E90 323I, ABS resetting.
hey hassa, if you swapped an ABS control unit from another vehicle, it needs to be coded to your vehicle. If your vehicle does not recognize the replacement vin, it will set a fault. also, make sure to have the ABS sensors calibrated after the control unit is coded. most dealers charge about 1hr labor to perform coding and sensor calibration.
SOURCE: 2006 BMW 325i E90 remote programming
That remote you purchased, did you remove your vehicle key from your old one and insert it into the new one? At the back of the remote there are pinch grips, pinch and pull to remove the key, you should have a plastic version of this key for your car, in the spare in the glovebox, unless it has been removed, check also in the owners manual folder, if you bought this car used it maybe in there. If you do not have the kaey that matches your car to put in the remote it will not program to the car. Hope this helps, let me know.
SOURCE: bmw e90 fuel
YOUR BATTERY SAFTEY TERMINAL MOST LIKELY BLEW (ON POSITIVE BATTERY CABLE ON RIGHT SIDE OF TRUNK). NEEDS TO BE REPLACED. SEE A DEALER.
SOURCE: co.zaMy 2006 BMW 320i E90
Flat battery. Your lights and other accessories draw alot less power than starter needs. Have your battery load tested to verify.
32 views
Usually answered in minutes!
×