- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
if it is an external filter you might need a special tool which can be purchased at autozone craftsman snap on it will have multiple colors in the set. but you use that tool to disconnect one side and the other side might be a bolt and you can use a philips screw driver to release the bracket it holds on to.
The fule filter is located in the engin compartment. Remove the air filter, and the compartment that houses it. Looking towards the fire-wall, and slightly down. The fule filter is located in the lower left. I suggest you purchase the fule filter first and this will help you find it. Use A LINE WRENCH too remove the bottom gas line. The top bolt can be removed with a scocked( all of these are Metric) The bottom one is a ******!!!
beside tank. Be careful, sometimes it helps to lower tank slightly. Special tools are needed, and if you break the top of the tank fitting, you will need a fuel pump.
The fuel pump is located in the fuel tank and is accessible once the rear seat cushion is removed and, the filter is located Under vehicle, driver side, below seating area,
driver side of fuel tank, mounted on frame in fuel
line.
its your fule filter theres 2 of them i the 86 ford ranger you need to change them the location of the fule filters are on google just tipe in fule filter 1986 ford ranger location it should pop up there about 8 dollors a peace easy fix and your truck is like new also get a new battey if you havent k have a good day. oh i know this because i own one had the same problem
The fule filter is up inside the frame on the drivers side. You will need to get special tools to get it off. Since it is a high pressure system you CANNOT cut it out and replace it. Must get the special tools.
if it is the 1500 you will need a spec. tool to disconect fitting (j46363) it is under the body just fallow the fuel lines, there will be a bracket with a fuel composition sensor with a wiring loom with 3 encased wires by your driveshaft, you will have to remove those nuts and posision the sensor aside to get to the fuel filter, from the picture on mitchelondemand it looks to be next to the suspension bar going through the chassie, if this helped alot throw me some blue ; ) take care any other quesions let me know
erik
ez automotive
×