How to drain oil fron tranmission and tork converter

when you drive a transmission on low oil transmission clutches pay the price have on the other hand when the torke converter fails there is no power try the oil and filter first see what happens or take it to a profesional good luck

if this unit has an over drive tork converter the tork converter or the TC valve (solenoid) might be faulty, have you tried keeping your foot on the gas a bit to keep it running ? and what happens ? also some engines have a low oil pressure warning and engine cut out , did you check your oil ???

The 60K service on this vehicle requires the following....

Change engine oil and engine oil filter. X X X X X Change rear axle fluid. X X Change front axle fluid (4X4). X X Inspect brake linings. X X Inspect engine air cleaner filter, replace if necessary. X Replace spark plugs. X Inspect PCV valve, replace as necessary.* X Inspect auto tension drive belt and replace if required. X Drain and refill transfer case (4X4). X Drain and refill automatic tranmission fluid, change filter and adjust bands (3.7L). X Drain and refill automatic tranmission fluid and change main sump filter (4.7L).

Hello
Welcome!
Oil pump is located on the oil pan.
Parts needed,,,oil,,,, oil filter,,,, oil pan gasket,,, oil pump,,,, oil pump pickup tube..
time to do this,, about 3 hours
Instructions,
Raise van place on 2 jack stands
drain oil remove oil filter fill new filter install.
remove bolts from oil pan,
remove oil pan..
remove 2 bolts that hold oil pump and tube.

install new pump and tube tork bolts to 45 fp
replace oil pan gasket and install oil pan
tork pan bolts to 35" pounds
install drain plug
fill with oil
start and check for leaks

let me know if i can help more

it is an AT and the color is change to a grey color. why i aske the question is a flush cost $150 buck and an oil change $40 so i am wondering if the mechanic whant to make more money. I call 2 repair center and goth 2 diffferents answer on said flush the other one said only change oil as the madza 3 have a screen in the transmission that clean the oil of all small particule

THERE IS NONE.YOU NEED TO REMOVE THE TRANSMISSION PAN TO DRAIN IT .IT CAN BE A MESSY JOB BUT IT'S THE ONLY WAY.

Torque Converter

Look for loose wires around the transmission, if you find any plug them back in. Ever change your transmission oil before? When? How long has it been?

I would be best to just change the oil and filter since all the oils drained out. Make sure you have the right gasket and you will have to use a tork wrench and tighten the bolts on the oil pan as the maufacturer recomends. Make sure you know the exact amount of tork you need so a leak doesn't develop.......I hope this is helpful : )

pull the botom of the oil pan and spacer and then u can pull the torke converter bolts

hi is it mannuall or automatic if its mannual you will a clutch lining tool to line the clutch disc before tightening the pressure plate if its auto you need to put the toruqe converter into the gearboxes housing and align the converters forks into the gearboxes oil pump by gently turning the converter and pressing lightly you will feel the converter slotting in keep revolving the converter till its full in be carfull otherwise you will damage the gearbox seal or pump then fasten box to engine and through the starter opening line the flywheel retaining bolts with converter don,t tighten them up until you have all the bolts in