Question about 1998 Jeep Cherokee

Open Question

I just bought a new turn signal switch for my jeep grand cherokke why wont my turn signal work when i try to use them

Posted by on

Ad

6 Suggested Answers

6ya6ya

6ya staff

  • 2 Answers

SOURCE:

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Anonymous

SOURCE: 2001 JEEP GRAND CHEROKKE LAREDO

turn the key from the off position to the run position(not all the way to start) when the system makes one beep turn it back to off. repeat three times. this will reset the obd II computer. if you do this correctly the odometer will read some words like reset or something

Posted on Aug 13, 2008

Ad

Anonymous

  • 2 Answers

SOURCE: turn signal

try a flasher

Posted on Sep 19, 2008

Anonymous

SOURCE: 2000 Jeep Grand Cherokee turn signal problems

if its a rear lamp they have had aproblemb with the circuit board in the lamp assy itself may need a new lamp

Posted on Oct 01, 2008

Marc Podeszek

  • 840 Answers

SOURCE: Turn signals quit working

one of the bulbs is not working soneither ill work so you need to check both bulb check the rear first its the easiest 2 screws inside rear and pull out light

Posted on Jan 25, 2009

emissionwiz

Marvin

  • 85206 Answers

SOURCE: Turn signals not working on 2001 Jeep Grand Cherokee

replace the turns signals flasher unit.

Posted on Mar 02, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Jeep grand cherokke 2007 mutlifunction switch wouldnt work so i bought a new wont and the lights come on but the turn signals wont work please help me


Have to work off of a wiring diagram & do some testing

You DO NOT Replace ANY Parts, until your testing finds
problem,then a failed part

Jul 03, 2014 | 2007 Jeep Grand Cherokee

1 Answer

1999 jeep grand cherokee rear wiper not working.replaced motor and fuse is good


join a grand cherokee forum by googleing it and post this and all future questions there

Feb 04, 2013 | 1999 Jeep Grand Cherokee

1 Answer

A/c clutch on '98 jeep grand cherokke won't


sounds as though there is a leak, check all connections on a/c lines, now you will need to see if the clutch is getting power, if it is then the clutch will need replaced, if not then check to make sure where the fuses and relay plug into are receiving power. Hope this helped Tim

Jun 07, 2011 | 1998 Jeep Grand Cherokee

1 Answer

My left turn signal wont work in my 2001 jeep grand cherokee


IF LEFT TURN SIGNAL BULB GOOD.TURN SIGNAL SWITCH COULD BE FAULTY.

Dec 06, 2010 | 2001 Jeep Grand Cherokee

2 Answers

All turn signals on my jeep cheroke laredo are not working. Is the problem a bad fuse??


COULD BE BLOW FUSE.FAULTY TURN SIGNAL SWITCH OR FAULTY TURN SIGNAL FLASHERS WHICH IS LOCATED FUSE / RELAY BOX JUST LEFT OF THE STEERING COLUMN.

Dec 05, 2010 | 2003 Jeep Grand Cherokee

1 Answer

2004 Grand Prix turning Signal lights wont work.


YOU HAVE TO REPLACE THE TURN SIGNAL SWITCH.BECAUSE WHEN IT GOES OUT.SOME TIMES YOUR DIMMER SWITCH STOP WORKING.IF YOU GOING TO FIX IT YOUR SELF BESURE TO.DISARM AIR BAGS FIRST.

Aug 19, 2009 | 2004 Pontiac Grand Prix

1 Answer

I need a fuse diagram for a jeep Grand cherokke larado


A very common issue with that particular transmission is the "Neutral Safety Switch". Check fuses of course. But if that is ok then try this. The neutral safety switch is located on the drivers side of the transmission case just above the trans pan. Pull off the three wire connector and jump to two out board terminels (a paper clip will do). Turn on the key and your backup lites should be on. FYI: By the way the center terminel is the neutral safety part (it grounds to the trans). Replacing it is a matter of unscrewing it . Be aware you will get some trans fluid leakage and this switch has a gasket that may or may not stick to the case. Make sure the gasket is there or you will have a leak. (new one would be good but they can be reused) There have also been issues with the rear lighting harness connector located in the rear corners by the tail lites. (usually those create lamp outage warnings with the Vehicle Information Center) Good luck

Mar 29, 2009 | 1993 Jeep Grand Cherokee

1 Answer

Running lights work but not the turn signals


You need a new Multifunction switch...Its very common. The switch controls those functions and more. Its hard to explain how it works but I am pretty sure thats what it is.....

Jul 22, 2008 | 1994 Jeep Grand Cherokee

Not finding what you are looking for?
1998 Jeep Cherokee Logo

Related Topics:

76 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jeep Experts

Marvin
Marvin

Level 3 Expert

85206 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22484 Answers

Jonah Oneal

Level 3 Expert

14092 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...