My dodge dacota 2005 haf a code po700 wat isthe problen on my trock

You sure it is P0888 I could not find definition for that recheck it.

In the causes for po888 the main reason is sensor circuit malfunction with the wiring poor connection being listed. Check that the wiring connectors are free of moisture and that the pins are clean and tight. code p0700 is straight out TCM problem so again I would be carefully inspecting the wiring and connections at both ends

IT'S YOUR SHIFT SOLENOID LOCATED IN THE PAN UNDER FILTER WITH 2 WIRES GOING TO IT NEEDS REPLACED OR YOU WILL RUIN YOUR TRANSMISSION THE SOLENOID CODE IS PO755 YOUR PO700 IS WHAT MAKES YOUR LIGHT LUMINATE UNTIL PROBLEM IS RESOLVED

here you go E A T X controler dtc present "specific fault must be aquired from the EATX via CCD or from aisin via ISO 9141 ,i'm not sure i know what it is ,but this is the best i could do ,good luck hope it helped.

that code usually means transmission control system malfunction.. Take it to AAMCO or another reputable service shop and they willl be able to dig a little deeper

You need to have the transmission control module scanned for codes. PO700 is just a code in the ecm to tell you that there are codes stored in the TCM.

That code is for a transmission problem.

If you DO have a weak battery, it is best to replace it before winter comes. If you are unsure if it is really weak or not, just about any auto part store will test it for free.

hello there
hey i got knocjked off the i net could you please get back wioth me here and we can continue from there

po700 transmission control system malfunction. and po740 torque converter clutch malfunction in solenoid/trans. relay circuit. hope this will help!!!!

the po700 code will be found in the engine controller all it means is there is a code preasent in the trans controller a good scan tool is needed to communicate with trans controller to retrieve the stored codes that specify problem