WHERE IS THE FUSE FOR THE TURN AND HAZARD LIGHTS

Diagnose Turn Signal Problems eHow

If the hazard flasher is working but the turn signals aren't, the problem is most likely either fuse A11 or the #2 relay in the trunk fuse block. However, if these check out, the problem could be either the turn/hazard switch assembly or the turn flasher module.

If both the turn signals and hazard flasher are not working, the most likely problem is the turn/hazard switch assembly.

YOU MIGHT HAVE A BURNT OUT RELAY IN FUSE COMPART UNDER YOU CARS HOOD CHECK THAT OUT THRU YOUR CARS MANUAL,IT WILL SHOW YOU WHICH RELAY IT IS?

if turn signals work, check flasher for hazard lights, you can swap with turn flasher to test

sounds like it is either flasher or switch assembly.

FIRST Check for Blown Fuse Then Locate Flasher Units @ Fuse Block to Determine Wiitch one is Hazard Turn On Key Then Turn Syg. Feel Flashers The One you feel Clicking is For Turn The Other IS Flasher Replace this Flasher unit.

1. Verify the customer's concern by operating the turn signal/hazard flasher lamp to duplicate the condition.
2. Inspect to determine if one of the electrical concerns apply: VISUAL INSPECTION CHART Electrical

• Circuitry open/shorted.
• Fuse junction panel Fuse:

+ 15 (10 A) + 29 (15 A)

• Damaged multi-function switch.
• Miniature bulb burned out.
• Damaged lamp.

1. If the inspection reveals obvious concern(s) that can be readily identified, service as required.
2. If the concern(s) remains after the inspection, determine the symptom(s) and go to the Symptom Chart. See: ProceduresSymptom Chart(s)

replace the hazard light switch, that is the only thing that can cause this problem

i bet you have a bad multi function switch or turn sig switch. good luck