WHAT IS RDI MEANS ? - 1991 Toyota Camry

Engine compartment

Toyota Matrix - fuse box - engine compartment

Instrument panel

Toyota Matrix - fuse box - instrument panel

Fuses (type A)

Fuse Ampere rating Description 1 FOG 15 Front fog lights 2 HEAD LH UPR 10 Left?hand headlight (high beam) 3 HEAD RH UPR 10 Right?hand headlight (high beam), high beam indicator light 4 SPARE 30 Spare fuse 5 SPARE 15 Spare fuse 6 SPARE 10 Spare fuse 7 ETCS (1ZZ?FE engine with two?wheel drive models only) 10 Electronic throttle control system 8 AMP 30 Car audio system 9 MAIN 30 Starting system, "AM2" fuse 10 DOME 15 Car audio system, clock, personal lights, interior light, trunk light, open door warning light, wireless remote control system 11 HORN 10 Horn 12 HAZARD 10 Emergency flashers, turn signal lights 13 EFI 15 Multiport fuel injection system/sequential multiport fuel injection system, emission control system, "EFI" fuse 14 ALT?S 5 Charging system 15 HEAD LH LWR 10 Left?hand headlight (low beam) 16 HEAD RH LWR 10 Right?hand headlight (low beam) 17 EFI2 (1ZZ?FE engine with two? wheel drive models only) 15 Multiport fuel injection system/ sequential multiport fuel injection system, emission control system 18 TAIL 15 Tail lights, license plate lights, instrument panel lights, instrument cluster lights, clock 19 OBD 7,5 On?board diagnosis system 20 WIPER 25 Windshield wipers 21 AM2 15 Charging system, multiport fuel injection system/sequential multiport fuel injection system, starting system, SRS airbag system 22 STOP 15 Stop lights, high mounted stoplight, anti?lock brake system, shift lock control system, multiport fuel injection system/sequential multiport fuel injection system, cruise control system 23 DOOR 25 Power door lock system, glass hatch opener switch 24 AM1 25 "CIG" fuse 25 ECU?IG 10 Electric cooling fan, anti?lock brake system, traction control system, vehicle stability control system, brake assist system, shift lock control system, cruise control system 26 RR WIPER 15 Rear window wiper 27 A/C 10 Air conditioning system 28 INV 15 Power outlet (115 VAC) 29 P/POINT 15 Power outlet (12 VDC/ in the rear console box) 30 ECU?B 10 Daytime running light system 31 CIG 15 Power outlet (on the instrument panel) or cigarette lighter, car audio system, clock, power rear view mirror control, shift lock control system 32 GAUGE 10 Gauges and meters, air conditioning system, daytime running light system, charging system, auto anti?glare inside rear view mirror, power windows, cruise control system, rear window defogger, back?up lights, front passenger's seat belt reminder light 33 WASHER 15 Windshield washer, rear window washer 34 M?HTR/DEF I?UP 10 Engine control system

Fuses (type B)

Fuse Ampere rating Description 35 ABS NO.1 30 Anti?lock brake system, vehicle stability control system, traction control system, brake assist system 36 RDI FAN 30 Electric cooling fan 37 ABS NO.2 40 (without vehicle stability
control system) Anti?lock brake system 50 (with vehicle stability
control system) Anti?lock brake system, vehicle stability control system, traction control system, brake assist system 38 HEAD MAIN 40 "HEAD LH UPR", "HEAD RH UPR", "HEAD LH LWR" and "HEAD RH LWR" fuses 39 AIR PUMP 50 (1ZZ?FE engine with four?wheel drive models and 2Z ?GE engine only) Emission control system 40 HTR 40 Air conditioning system 41 DEF 30 Rear window defogger, "M?HTR/DEF I?UP" fuse 42 POWER 30 Power windows, electric moon roof

Fuses (type C)

Fuse Ampere rating [A] Description 43 ALT 100 Charging system, "ABS NO.1", "ABS NO.2", "RDI FAN", "FOG", "HTR", "AM1", "POWER", "DOOR", "ECU?B", "TAIL", "STOP", "P/POINT", "INV" and "OBD" fuses WARNING: Terminal and harness assignments for individual connectors will vary depending on vehicle equipment level, model, and market.

Check the under hood fuse and relay center for a 30 amp fuse marked RDI-1 also the cooling fan relay right next to the fuse. Did you check for current at the motor? If there is current there with the switch on change the coolant temperature sensor. If no current and the fuse is good suspect the relay and swap it with one with the same number. I hope this helps. Take care.

Radiator Fuse

Where is nin Sensor located in 1az engine sienta

This is called a RDI.. Remove, dissemble and inspect. I did notice you have other codes. 1 of 8. Those other codes could be a problem with the 734 code. Year make and model helps...

By that year they should be electrically driven. Check your cooling fan relay, RDI fuse, and coolant temperature switch. See here p261

http://www.turboninjas.com/camry/eg1.pdf

It could be:

- blown fuse (RDI -M fuse, 30A, in Relay block 5)
- failed relay (fan relay, same location)
- failed engine temp sensor (quite likely)
- broken wiring connector
- failed fan motor (not that likely)

Test procedures are here, after p261

http://www.turboninjas.com/camry/eg1.pdf

After seeing a broken cam the dealer should have recommended a RDI of the engine(remove, disassemble and inspect). Cams don't break on their own. Low oil pressure is usually the cause and will damage other internal parts such as rod and main bearings.After the RDI a complete list of the damage would have been had and you could have made a decision from there. It was rather irresponcible of the dealer to just replace ther head and cam without the RDI.

Hi.....

The Normal Temperature Range to the Fan Start is: A/C ON 181 F.
A/C OFF 199 F. When the Engine Reach this Temperature the Fan should start.

OK. Do this simple test.
1---- Start the engine, Desconnect the ECT Switch located on the Radiator,
See if the Fan come ON. If yes, if not go to step #2
Connect the ECT SWITCH and leave the car Running and with a Temperature gage.
See the temperature, if the Temperature go more than 199 F.
Turn the Engine OFF.
Disconnect the ECT sensor and check for Ground at the WHITE/BLACK wire.
If ground exist, Replace the ECT switch.
But if not. Check the wire for any damaged, and the ground at the Front Left Fender.
Repair as need.

2---- check the Fuse link RDI FAN . 30 amp.
Check the Fuse link CDS FAN 30 amp.
Replace if need.
And Return to step # 1.
Check the Radiator fan Relay, Rad fan relay 2 and 3. Replace if need.

Ok. I hope this help on your question.
I can give to you the WIRING DIAGRAM of the Fans, But I need a E-MAIL adress to do that.

Thank you for use fixya....

You should check the 30 amp "RDI" fuse and the 7.5 ECU-IG fuse. Both fuses are critical to the operation of the fan system. The RDI fuse sends power to the fan #1 relay. The A/C amplifier turns on power to the fan #1 relay, this is why your fan works on A/C.

Now, with no cooling fan under "normal conditions" (A/C off), you need to have a good fan #2 relay, and a good water temp switch. This switch is on the engine, near the thermostat housing (I think); with a single plug, with a white with a blue trace wire going to it. Remove this wire from the sender, and jump it to ground (anywhere on the metal of the engine) with the key on (engine OFF). If the fan starts, you need a new water temp sending unit. If not, then consider a new fan #2 relay. This system is pretty simple.