Need to remove driver seat cushion yukon xl 2001

SOURCE: replace rear brake pads on 2001 yukon xl

First remove the cap off the master cylinder. Push in the piston on one caliper with a c clamp, or pry it back between the pad and rotor with a prybar. Then remove the 2 bolts on the caliper itself. Replace pads.Go to other side, repeat sequence

SOURCE: replace factory radio on 2002 yukon xl

all you gotta do is carfully pry the dash panel off (prying from the far left end is easiest) completely remove panel. then there are 2 clips that hold the factory sterio in place. push on the both clips while pulling the radio out. simply disconnect the wiring harness from the back of the radio. using an adapter avaliable at your local radio shop (scosche p/n gm02, mdarb and gm1483b) wiring harness, dash install kit, and antenna adapter. then simply match the colors on the new radio's harness to the adapter harness, crimping each connection with a "but plug". then simply follow the instructions included with the dash install kit to assemble the kit.connect the antenna adapter to radio, plug in all cables. test to see if everything works properly before the final install. install sterio into dash install kit, re installing kit where origional radio was. then simply put the panel back in its place by firmly pushing on it untill it snaps into place. then enjoy your new radio!

SOURCE: my 2006 gmc yukon xl drivers seat will not move

Under the drivers seat at the rear is a black plastic cover. Remove the cover , it is over the main harness to the seat. Unplug the seat harness and inspect the connection. I see alot of these get knocked loose or get corroded. Good Luck.

SOURCE: I have a 2005 GMC Yukon XL and my heater only

Your heater problem is more than likely a bad temp door motor.The seat heater problem is probably one of your elements.Either back or bottom.If your switch light is coming on then the element is bad.

SOURCE: How do you remove factory stereo amplifier on 2001

There is an outer trim that circumferences the Dash and radio panels. This trim is a snap in. I pulled mine out by hand. After pulling the trim loose I had to lower the steering column all the way and put the car in drive to easily remove the loosened trim.